Filter
Top Products
7 - 7
7.3 Programming Example when GX Configurator-CT is Used
7
PROGRAMMING
* 1 Set this only when using the latch counter function.
* 2 Set this only when using the linear counter function.
* 3 Stores last occurred error and holds it even after error reset.
* 4 Stores last occurred warning and holds it even after error reset.
* 5 Set this only when using the coincidence output function.
* 6 Set this only when using the continuous comparison function.
(2) Operating the GX Configurator-CT
(a) Initial setting
Set the initial settings of CH1 and 2.
Refer to Section 7.2 for the settings.
For Initial setting in GX Configurator-CT, refer to Section 6.4.
Figure 7.4 [Initial setting] screen
Table 7.2 List of devices (continued)
Device Function
Y30 CH1 coincidence confirmation LED signal
QY40P (Y30 to Y3F)
Y31
*2
CH1 overflow occurrence confirmation LED signal
Y32 CH2 coincidence confirmation LED signal