Filter
Top Products
8 - 13
8.11 Action and Handling of Errors
8.11.2 Warning code list
8
TROUBLESHOOTING
8.11.2 Warning code list
This section describes the descriptions and corrective actions for the warnings detected by
the QD64D2.
POINT
• When another warning occurs during warning occurrence, the warning
code is overwritten as the latest one.
• After fixing the cause of the warning, reset the warning by the error reset
command (Y0D). If the cause of the warning is not fixed, the warning is
detected again.
Table 8.20 Warning code list
Warning
code
Description Action
Operation at warning
Warning channel Other channels
0 (Normal) ---- ---- ----
3m
[Coincidence output No.m test output not possible]
Turn OFF the all signals listed
on the left.
The coincidence
output test cannot
be started.
(The warning does
not affect the other
coincidence output
number.)
The warning
does not affect
other channels.
The coincidence output No.m test command (Y0B
and Y0C) is turned ON while one of the following is
ON.
•Count enable command (Y06)
•Continuous comparison No.1 execution command
(Y09)
•During continuous comparison No.1 execution (X09)
•Continuous comparison No.2 execution command
(Y0A)
•During continuous comparison No.2 execution (X0A)
"m" indicates the continuous comparison number
where the warning occurred.