Filter
Top Products
5 - 68 FUNCTION REFERENCE
SETUPS SEQUENCE
Description:
If front panel settings are stored in memory locations ‘s1 to s5’ and ‘s6’ is cleared,
then the range of ‘s1 to s5’ is referred to as a sequence. Such a sequence can be
used as (part of) a step-by-step testing procedure. There are two possible ways
to step through a sequence without have to recall each individual setup using the
menus:
- By programming the AUTOSET key to be used as the ‘recall next setup’ key.
This selection can be done in the UTILITY >> AUTOSET menu.
- By using a probe with a COMMAND switch. Each instrument is delivered with
two such probes, as standard accessory. The appropriate mode for this probe
command can be selected in the UTILITY >> PROBE menu.
To return to the ‘normal’ oscilloscope mode, recall the STANDARD SETUP by
simultaneously pressing the STATUS and TEXT OFF key.