Filter
Top Products
3 - 4 GETTING STARTED
3.4 AUTO SETUP
The best way to start each measurement is by using the AUTOSET key. This
automatically
finds and scales all relevant parameters on all channels.
Step 1 Connect the probe as shown in figure 3.3.
NOTE: AUTOSET is programmable. Because you have set the instrument in the
"standard setup" before (see Section 3.2), all programmable features are
set to a predefined condition and the instrument is set in the analog mode.
Programming of AUTOSET is explained in Chapters 4 and 5.
Step 2 Press the
AUTOSET
key.
The scope flashes the message ’AUTO SETTING...’ on the screen. In
a few seconds the front-panel settings are adjusted for an optimized
display of the applied signal in the analog mode.
Step 3 The calibration signal is clearly displayed.
The parameters of the channel and the timebase settings are
displayed at the bottom of the screen.
1
23
4
AUTO SET
ST6659
9303
Figure 3.3 Measuring setup
CH1
200mV
MTB 200µs
CH1
ST6704