Filter
Top Products
THE CPL PROTOCOL 6 - 7
AUTOSET AS
Purpose:
To start the AUTOSET function. With this command the oscilloscope will select
the optimum settings (volts, time base, trigger mode, etc.) for the connected
signal(s).
The AutoSet (AS) command performs the same function as pressing the front
panel AUTOSET button.
Command:
Response:
Note: The <acknowledge> will be sent after the AUTOSET has been fully
completed.
Example:
100 PRINT #1,"AS" :’Send command
110 GOSUB 1000 :’Sync on acknowledge
"AS" CR
acknowledge CR