Filter
Top Products
4 - 42 HOW TO USE THE INSTRUMENT
TRACE STORAGE RECALL
If you completed all of the previous steps, three memory locations are
occupied by trace information. You can display these stored traces at
any time and in any combination.
- Press the RECALL key.
- Turn the TRACK control to select ’m1’.
- Press the ’DISPLAY on off’ softkey to display m1.
Observe that the stored trace on memory location ’m1’ is displayed and that the
circle before m1 is solid.
An open circle indicates an empty memory location.
A circle with a dot indicates that there is a trace stored, but it is not displayed.
A solid circle indicates trace data in memory are displayed on the screen.
Empty memory locations cannot be displayed.
You can shift traces separately over the screen by means of the ∆ control.
- Turn the POSition control.
The live trace shifts.
- Turn the TRACK
control to select ’m2’.
- Press the ’DISPLAY on
off’ softkey to on.
-
Turn the
∆
control.
Observe that the second stored trace shifts.
RECALL
DISPLAY
on off
T
CLEAR
DISPLAY
Y-POS
−2.30D
∆
trace
register
RECALL
REGISTER
MEMORIES
acq
m1
m2
∆
POS
ST6722
9303