Filter
Top Products
HOW TO USE THE INSTRUMENT 4 - 5
4.2 DISPLAY AND PROBE ADJUSTMENTS
To help you follow the step-by-step descriptions, each section begins by recalling
the standard setting as outlined below.
If you get "lost", you can return to the beginning of each section, because all
functions are set to a predefined state to create a correct start situation.
RECALL STANDARD SETTING
- Simultaneously press the STATUS and TEXT OFF keys.
Recalling the standard setting always results in a trace on the display, even with
no signal applied to the oscilloscope inputs. Refer for a list of the standard setting
to the section "STANDARD SETUP/FRONT PANEL RESET" of Chapter 5.
DISPLAY ADJUSTMENT
Before going through the examples that introduce you to
features of this oscilloscope, adjust the display as follows:
- Turn the TRACE INTENSITY control for optimum trace
brightness.
- Turn the TEXT INTENSITY control for optimum
display brightness of the text.
- Adjust trace alignment with the graticule by using the
screwdriver control TRACE ROTATION.
- Turn the FOCUS control until a sharp trace is
obtained.
- You can turn the GRATICULE ILLUMINATION control
to illuminate the graticule lines as desired.