Filter
Top Products
Basic Disk Mode
The Multiple Object Selector Page
13-39
Entering Selection Criteria in the Multiple Object Selector
This section describes the operation of the selection modes provided on the Multiple Object
Selector page. These are accessed by scrolling the Select: parameter to different values, as
pictured above.
Type/Range Mode
This mode lets you select objects based on their type, and on a particular range of object IDs.
It is possible to set the EndId before the StartId. If this is the case, the selection range is empty.
Parameter Possible Values Function
Type Sample, Keymap,
Effect, Program,
Setup, QABank,
VelMap, PrsMap,
IntTbl, Song, Table, All
Types
Sets the desired object type. The value All Types will select all of
the other possible types.
Bank 000s, 100s, 200s,
300s, 400s, 500s,
600s, 700s, 800s,
900s, All Banks
Sets the desired bank. Changing this parameter causes the
StartId and the EndId to be set to the limits of the chosen bank (for
example, a value of 300s sets the StartId to 300 and the EndId to
399). A value of All Banks sets the StartId to 0 and the EndId to
999.
The actual range used for selections when Toggle, Set, or Clear is
pressed is taken from the setting of the StartId and EndId
parameters. For example, if you set the Bank to 200s and then
change the StartID to 300 and the EndID to 399, the 300s bank
will be selected, not the 200s.
The Bank parameter is used as a quick way to set up the ID range
for an entire bank, or all banks.
StartID 0–999 Sets the specific starting ID of the selection range.
EndId 0–999 Sets the specific ending ID of the selection range.
Table 13-2 Object Selection by Type / Range