Filter
Top Products
125
Basic functions
Saving dataLoading dataProgram
settings
Combination
settings
Producing
songs
Sampling
settings
Creating a
CD
SMF
playback
System
settings
Drum kit
settings
Arpeggiator
settings
Effects
settings
Other
functions
Recalling the last-selected mode
and page at power-on
The state of TRITON STUDIO when the power is turned
on will depend on the setting of “Power On Mode” (Glo-
bal P0: System Preference page).
If “Power On Mode” is Reset (factory setting), TRITON
STUDIO will automatically selects the Combination mode
P0: Play.
If “Power On Mode” is Memorize, TRITON STUDIO will
be in the mode and page that were last selected when the
power was turned off.
The Memorize setting will remember the mode and page
that were last selected, the combination number that was
last selected in Combination mode, and the program
number that was last selected in Program mode. If
another mode is selected when the power is turned on,
you can press the [COMBI] key or [PROG] key to select
the P0: Play page with the last-selected combination num-
ber or program number.
Specifying the function of the
ASSIGNABLE Switch and
ASSIGNABLE Pedal
Sets the function of an assignable switch such as the
optional Korg PS-1 connected to the ASSIGNABLE
SWITCH jack.
This switch can act as a source for alternate modulation or
effect dynamic modulation, or switch portamento on/off,
control the sostenuto effect, turn the soft pedal effect on/
off, turn the arpeggiator on/off, select programs or combi-
nations (up/down), start/stop the sequencer, punch-in/
out on the sequencer, or be a trigger to advance the cue list
step (☞PG p.251).
• This setting is made in Global P2: Controller “Foot
Switch Assign.”
You can specify the function that will be performed by an
assignable pedal (the optional XVP-10 or EXP-2) con-
nected to the ASSIGNABLE PEDAL jack.
This pedal can be used to control master volume, alternate
modulation or effect dynamic modulation, portamento
pitch change speed, volume, the pan following an insert
effect, pan, volume, or send levels to the master effects
(☞PG p.252).
• This setting is made in Global P2: Controller “Foot
Pedal Assign.”
You can use this as a source for alternate modulation
or effect dynamic modulation, and use it to control
program parameters or effect parameters. In this case,
set “Foot Switch Assign” to Foot SW (CC#82), and
“Foot Pedal Assign” to Foot Pedal (CC#04).
Here we will show how to make settings that allow an
assignable switch to change programs or combinations.
1 Connect an optional Korg PS-1 to the ASSIGNABLE
SWITCH jack.
2 Press the [GLOBAL] key to enter Global mode.
3 After pressing the [MENU] key, and press the P2:
Controller.
4 Press the “Foot Switch Assign” popup button, and
press either Program Up or Program Down.
Program Up will cause the next higher program num-
ber to be selected each time you press the foot switch.
Program Down will cause the next lower program
number to be selected each time you press the foot
switch.
5 Set the “Foot Switch Polarity” to the polarity of the
foot switch you have connected.
If you have connected a Korg PS-1 pedal switch, set
this to (–) KORG Standard. If the polarity is not set
correctly, the pedal will not function appropriately.
6 Either press the [PROG] key to enter Program P0:
Play, or press the [COMBI] key to enter Combination
P0: Play. When you press the foot switch, the pro-
gram/combination will change.