Filter
Top Products
104 MIDI
01V96i—Reference Manual
Assigning Parameters to
Control Changes for
Real-time Control
You can assign 01V96i parameters to MIDI Control Changes
for real-time control. When the 01V96i receives a Control
Change, the assigned 01V96i parameter is set accordingly.
Also, when you adjust a parameter on the 01V96i, the 01V96i
transmits the assigned Control Change message.
1. Press the DISPLAY ACCESS [DIO/SETUP] but-
ton repeatedly until the DIO/Setup |
MIDI/Host page appears, then specify ports
for transmission and reception of MIDI mes-
sages (see page 101).
2. Make connections using the ports selected in
Step 1 so that the 01V96i can transfer MIDI
messages to and from the external device.
3. Press the DISPLAY ACCESS [MIDI] button,
then press the [F3] button.
The MIDI | Ctl Asgn page appears. This page enables you
to assign 01V96i parameters to Control Changes.
4. Move the cursor to the MODE parameter’s
TABLE button (
1), then press [ENTER].
The MODE parameter determines which MIDI messages
are transmitted when 01V96i parameters are adjusted.
The following options are available for the MODE
parameter:
•TABLE
MIDI Control Change messages are transmitted in accor-
dance with the assignments on this page.
• NRPN
The assignments on the Ctl Asgn page are ignored, and
predefined NRPNs (Non Registered Parameter Num-
bers) are transmitted for remote control.
5. If you turned on the TABLE button in Step 4,
move the cursor to a parameter box in the No.
(CH) column, then rotate the Parameter
wheel or press the [INC]/[DEC] buttons to
select the MIDI channels and Control
Changes to which you want to assign param-
eters.
You can assign parameters to up to 16-channel Control
Changes on the Ctl Asgn page, regardless of the MIDI
Channels currently selected for transmission and recep-
tion.
Skip Steps 5 and 6 if you turned on the NRPN button in
Step 4.
6. Select parameters in the parameter boxes in
the three PARAMETER columns.
Select a parameter group in the parameter box in the first
PARAMETER column, and specify the desired values in
the parameter boxes in the second and third PARAME-
TER columns.
The following parameters and values are available:
Tip: You can store a Parameter to Control Change assignment
table to an external device by using MIDI Bulk Dump or the Stu-
dio Manager software.
Tip: See page 157 for information on the default Parameter
to Control Change assignments.
1
Tip: NRPNs are special MIDI messages that combine three
different Control Changes. They enable you to control many
parameters on a single MIDI Channel.
HIGH MID LOW
NO ASSIGN ——
FADER H
CHANNEL INPUT1–32/ST IN1–4
MASTER BUS1–8/AUX1–8/STEREO
AUX1 SEND
INPUT1–32/ST IN1–4
AUX2 SEND
AUX3 SEND
AUX4 SEND
AUX5 SEND
AUX6 SEND
AUX7 SEND
AUX8 SEND
BUS TO ST BUS1–8
FADER L
CHANNEL INPUT1–32/ST IN1–4
MASTER BUS1–8/AUX1–8/STEREO
AUX1 SEND
INPUT1–32/ST IN1–4
AUX2 SEND
AUX3 SEND
AUX4 SEND
AUX5 SEND
AUX6 SEND
AUX7 SEND
AUX8 SEND
BUS TO ST BUS1–8