Filter
Top Products
66 Internal Effects
01V96i—Reference Manual
4. Select the effect insertion position using the
INSERT button in the POSITION section.
5. Move the cursor to the OUT parameter box
in the INSERT section, then select the inputs
of the effects processor selected in Step 1.
• FX1-1 & FX1-2 ......Inputs 1 & 2 of Internal Effects Pro-
cessor 1
• FX2-1 & FX2-2 ......Inputs 1 & 2 of Internal Effects Pro-
cessor 2
• FX3-1 & FX3-2 ......Inputs 1 & 2 of Internal Effects Pro-
cessor 3
• FX4-1 & FX4-2 ......Inputs 1 & 2 of Internal Effects Pro-
cessor 4
6. Press [ENTER] to confirm the setting.
7. Move the cursor to the IN parameter box in
the INSERT section, select the outputs of the
effects processor selected in Step 1, then
press [ENTER] to confirm the setting.
8. Move the cursor to the ON/OFF button in the
INSERT section, then press [ENTER] to turn on
the button.
Effect insertion is now enabled.
Editing Effects
To edit effect programs recalled to the internal Effects proces-
sors 1–4, press the DISPLAY ACCESS [EFFECT] button
repeatedly until the Edit page for the effects processor you
wish to edit appears.
Effects processors 1–4 correspond to the following pages:
• Effects Processor 1 .............FX1 Edit page
• Effects Processor 2 .............FX2 Edit page
• Effects Processor 3 .............FX3 Edit page
• Effects Processor 4 .............FX4 Edit page
These Edit pages contain the following effect parameters.
1 EFFECT NAME
This parameter displays the name of the effect program
currently used by the effects processor.
2 TYPE
This parameter displays the type of effect program cur-
rently used by the effects processor. The I/O configura-
tion of the effect program is displayed below this
parameter.
3 button
Move the cursor to this parameter, then press [ENTER] to
display the Library page for the selected effects processor.
4 button
Move the cursor to this button, then press [ENTER] to
display the Patch | Effect page, which enables you to
assign signals to the inputs and outputs of Effects proces-
sors 1–4.
5 MIX BALANCE
This parameter knob enables you to set the balance
between wet and dry signals. When the parameter is set
to 0%, only the dry signal is heard. When set to 100%,
only the wet signal is heard. Turn on the BYPASS button
to bypass the currently-selected effects processor.
6 TEMPO
This section enables you to set the tempo and interval of
the selected effects, and displays certain parameters only
when certain effect types are selected. Use the parameter
control on the left side of this section to adjust the value
between 25 BPM and 300 BPM. When the MIDI CLK
Tip:
• After inserting effects to channels, adjust the MIX BAL-
ANCE parameter for the effects, according to the purpose
and effects type.
• Move the cursor to an empty IN or OUT parameter box
and press the [ENTER] button. The Patch Select window
appears, which enables you to quickly select available sig-
nal paths.
1243 7
5
6