Filter
Top Products
54 Surround Pan
01V96i—Reference Manual
The DIO/Setup | Surr Bus page appears.
1 BUS1–BUS8
These parameters select channels to be assigned to the
Bus Outs in 3-1, 5.1, and 6.1 Surround modes.
2 INIT
These buttons reset the channel assignment to the default
setting.
3 Surround LR to Stereo
When this check box is on, the left and right front signals
of the surround channels are output from the STEREO
L/R connectors.
7. To change the assignment, move the cursor
to the desired Bus parameter, rotate the
Parameter wheel to select a channel, then
press [ENTER].
The channels are swapped between the selected Bus and
the Bus to which the channel assigned to the selected Bus
was assigned previously.
8. Depending on the selected Surround mode
or applications, patch the Bus Out signals to
the outputs, ADAT OUT channels, or slot out-
put channels. Connect a playback device or
MTR to the output connectors.
■ Surround Pan Recording
To record surround pan movement to a DAW, patch the corresponding bus outs to the TO HOST USB port’s output channels, send-
ing them to the DAW’s tracks.
The following diagram illustrates an example of recording each channel’s signal into a DAW when using 5.1 Surround mode.
23 1
Tip:
• Pressing the DISPLAY ACCESS [SETUP] button repeat-
edly also displays the Surr Bus page.
• Available Bus Outs vary depending on the Surround
mode. For example, in 3-1 Surround mode, Bus Outs 1–4
are available. In 5.1 Surround mode, Bus Outs 1–6 are
available, and in 6.1 Surround mode, Bus Outs 1–7 are
available.
BUS1 (L)
BUS2 (R)
BUS3 (Ls)
BUS4 (Rs)
BUS5 (C)
BUS6 (LFE)
SURROUND
PAN
LFE LEVEL
SURROUND
PAN
LFE LEVEL
SURROUND
PAN
LFE LEVEL
01V96i
Input Channel 2
DAW
USB
USB 1
USB 2
USB 3
USB 4
USB 5
USB 6
Track 1
Track 2
Track 3
Track 4
Track 5
Track 6
Input Channel 1
Input Channel 3