Filter
Top Products
74 Libraries
01V96i—Reference Manual
Libraries
This chapter describes the 01V96i’s various libraries.
About the Libraries
The 01V96i features seven libraries that enable you to store
Channel, Input Patch, Output Patch, Effects, and other data.
You can also quickly recall this data from the libraries to
restore previous parameter values.
The 01V96i offers the following libraries:
• Channel Library
•Input Patch Library
• Output Patch Library
•Effects Library
•Gate Library
•Compressor Library
•EQ Library
General Library Operation
Most library functions are the same for each library.
1. Use the buttons on the top panel to locate the
desired library pages.
The procedure for locating library pages varies depend-
ing on the library. Refer to the latter part of this chapter
for more information on how to display the desired
library page.
The example below assumes you have located the Input
Patch library page.
The library memory title list is displayed in the middle of
the page. The message “No Data!” appears in the title col-
umn of empty library memories.
An “ ” icon is displayed next to the name of read-only
preset memories. You cannot store, clear, or edit the titles
of these memories.
Memories #0 and #U are special read-only memories.
Recall memory #0 to reset the parameter settings to their
initial values. Recall #U to undo memory recall and store
operations.
2. Rotate the Parameter wheel or press the
[INC]/[DEC] buttons to select the desired
memory.
The selected memory appears inside the dotted box.
3. Move the cursor to one of the following func-
tion buttons, then press [ENTER].
1 TITLE EDIT
This button displays the Title Edit window, which enables
you to edit the title of the selected memory. Move the cur-
sor to the OK button, then press [ENTER] to confirm the
edited title. Refer to “Title Edit Window” in the Owner’s
Manual (booklet) for more information on entering char-
acters.
2 RECALL
This button recalls the contents of the selected library
memory. If you turn on the Recall Confirmation param-
eter on the DIO/Setup | Prefer1 page, the 01V96i displays
a memory recall confirmation window.
3 STORE
This button stores the settings to the selected memory.
Before you store the settings, you can enter or edit the title
using the Title Edit window.
You can disable the Title Edit window by turning off the
Store Confirmation parameter on the DIO/Setup |
Prefer1 page. If you bypass the Edit Title window, the
name “New Data” will be used as a title for the Scene
memory.
4 CLEAR
This button deletes the contents of the selected memory.
After you press [ENTER], the 01V96i displays a confir-
mation window. To execute the delete operation, move
the cursor to the YES button in the confirmation window,
then press [ENTER].
Tip:
• You can store library data to a computer hard disk using the
included Studio Manager software. Be sure to back up your
important data.
• You can also store library data to an external MIDI device,
such as a MIDI data filer, by using MIDI Bulk Dump (see
page 107).
1
2
3
4
Note: If you select a memory that already contains settings
and execute the delete operation, the settings will be lost.
Make sure that you do not accidentally delete important set-
tings.