Filter
Top Products
TASCAM DP-006
13
2 – Quick Start Guides
CAUTION
•
Do not remove or insert an SD card when the unit’s power is ON. Make sure
the unit power is OFF (in standby) before you remove or insert an SD card.
•
If you remove or insert an SD card when the unit’s power is ON, all data
and settings that have been changed since the last shutdown or song
saving operation will be lost. These data and settings cannot be recovered.
•
When the unit power is ON, do not remove the batteries, disconnect the
power cable or otherwise cut the power to the unit.
•
The included alkaline batteries are for confirming operation of the unit
and might only be usable for a short amount of time.
•
The volume dial on the left side panel does not have any indications.
Before turning the power ON or OFF (putting it into standby), minimize the
volume on any connected external monitoring system (powered monitor
speakers or an amplifier and speakers).
•
Do not wear headphones when turning the power ON or OFF (putting it
into standby) because noise at such times could harm your hearing.
TIPS
•
This unit can also be powered by a TASCAM PS-P520 power adaptor (sold
separately). (See “Using an AC adaptor (sold separately)” on page 40.)
•
By connecting an external monitoring system (powered monitor speakers
or an amplifier and speakers) to the /LINE OUT jack on the left side of
the unit, you can monitor recordings using speakers.
Playing and mixing the demo song
Before the unit is shipped, a demo song is stored on its SD card. We are now
going to use basic playback and mixing features with this demo song.
1. Press the HOME button to open the Home Screen.
2. When the recorder is stopped, press the MENU button to open the
MENU
screen.