Filter
Top Products
92
TASCAM DP-006
12 – Exchanging Data with a Computer
Exporting stereo master tracks
When you create a new stereo master track for a song, the existing stereo
master track is overwritten, so if you want to keep multiple different stereo
master tracks, you should save them to a computer.
Before starting the following export procedures, make sure that the song for
which you want to export a stereo master track is currently loaded and that
you have already created a stereo master track for it.
1. When the recorder is stopped, press the MENU button to open the
MENU
screen.
2. Use the DATA wheel to select (highlight) the
IMPORT/EXPORT
item,
and press the F4 [t] button to open the
IMPORT/EXPORT
screen.
3. Use the DATA wheel to select (highlight) the
EXPORT MASTER
item,
and press the F4 [t] button to open the
EXPORT MASTER
screen.
NOTE
A
Master Track Not Found
warning pop-up message appears if
there is no stereo master track.
4. Edit the name (title) of the stereo master file as necessary. (See “Editing
names” on page 46.)
5. When done editing the file name, press the F2 [EXEC] button to export a
stereo master track as a single 16-bit, 44.1kHz stereo WAV file to the FAT
partition.
The file name of the exported file is the name set in step 4 above plus the
“.WAV” extension.
If you have previously exported a stereo master track with the same
name (title), a
Duplicate name Are you sure?
(A file with the
same name already exists. Are you sure that you want to overwrite it?)
confirmation pop-up message appears.
Press the F3 [YES] button to overwrite the old file.
Press the F4 [NO] button to cancel the export and return to the previous
screen where you can edit the name (title).
NOTE
To cancel exporting, press the F1 [BACK] button.
6. Press the HOME button to reopen the Home Screen.
7. Connect this unit to a computer using a USB cable. (See “Connecting with
a computer” on page 84.)
8. Use the computer to copy the stereo master file from the WAVE directory
on the FAT partition of the unit to the computer.
9. After copying finishes, remove the USB cable using the proper proce-
dures and disconnect the unit from the computer. (See “Disconnecting”
on page 85.)