Filter
Top Products
TASCAM DP-006
17
2 – Quick Start Guides
4. In order to use the built-in MIC B to record the guitar to stereo TRACK 3,
use the DATA wheel to set the input source for
IN B
(INPUT B) to
INT
MIC B-Low
,
INT MIC B-Mid
or
INT MIC B-High
. (See “Selecting
the input source” on page 51.)
5. After completing the setting, press the HOME button to return to the
Home Screen.
NOTE
•
INT.MIC X-Low
,
INT.MIC X-Mid
and
INT.MIC X-High
(
X
is
A
or
B
) settings change the sensitivity of the built-in mics. Set according to
the loudness of the subject being recorded.
If you are not sure which setting to use, choose
INT.MIC X-Low
. If the
input level is still too low after adjusting it, return to
INPUT SETTING
screen and change the setting to
INT.MIC X-Mid
. If the input level is
still not high enough, change the setting to
INT.MIC X-High
.
•
Set the
MODE
item on the
INPUT SETTING
to monitor the input
signals. (See “Setting the monitoring mode” on page 52.)
Setting the internal mics as the recording sources
for TRACK 3
When the recorder is stopped, press the ASSIGN button to open the
INPUT
ASSIGN
screen. By default the recording sources are assigned to the tracks as
shown below.
Recording track Recording source Default value
TRACK 1 INPUT A
IN A
TRACK 2 INPUT B
IN B
TRACK 3 INPUT A/B
IN A-B
TRACK 4 INPUT A/B
IN A-B
Since you set internal MIC A as the input source for INPUT A and internal MIC
B as the input source for INPUT B on the
INPUT SETTING
screen in the
previous “Setting the internal mics as input sources” section, signals from MIC
A and MIC B will be recorded to TRACK 3.
So, in this example, you do not need to change the input source assignment
settings to use the internal mics to record the rhythm guitar to TRACK 3.