Tascam D01175220A DP-006 Recording Equipment User Manual


 
62
TASCAM DP-006
7 – Recorder Functions
Using the bounce function
1. When the recorder is stopped, press the REC MODE button to open the
RECORDER MODE
screen.
2. Use the DATA wheel to select (highlight) the
BOUNCE
item.
3. Press the F4 [EXEC] button.
After a
Bounce!
pop-up message appears, the recorder enters
BOUNCE
mode, and the Home Screen reopens.
NOTE
When the recorder is in
BOUNCE
mode,
BOUNCE
appears highlighted at
the upper left of the Home Screen.
4. Press the TRACK REC buttons for the bounce destination tracks to light
their indicators.
For a stereo bounce, press two mono track REC buttons or one stereo
track REC button. (See “Setting the track type (Tracks 3 and 4 only)” on
page 54.)
Examples: Press the TRACK 1 and TRACK 2 REC buttons.
If the track type of TRACK 3 and TRACK 4 is set to
MONO
,
press the TRACK 3 and TRACK 4 REC buttons.
If the track type of TRACK 3 or TRACK 4 is set to
STEREO
,
press either the TRACK 3 or TRACK 4 REC button.
For a mono bounce (to a single track), press one mono track REC button
Examples: Press either the TRACK 1 or TRACK 2 REC button.
If the track type of TRACK 3 and TRACK 4 is set to
MONO
,
press either the TRACK 3 or TRACK 4 REC button.
NOTE
When the bounce destination track is mono,
IN A
(INPUT A) is recorded
regardless of the assignment settings.
TIP
You can record an additional performance to the bounce destination
track(s) while monitoring the mix that is being bounced to them. In other
words, you can overdub as you bounce.