Filter
Top Products
TASCAM GigaEditor 4 Manual 107
ere are two modes of operation, corresponding to the two main ways of using Giga crossfades:
Layers within a single instrument. is mode is used to apply crossfades to a single instrument which
contains a layer dimension. Normally in a layer dimension, all of the splits sound simultaneously, but
when crossfade points are dened, you can use a midi controller to crossfade between layers. Set the
“Number of layers” box to match the number of splits in your instrument’s layer dimension. e
crossfade points you dene (and the controller you select under “Attenuation control”) will be applied
to the instrument when you press Apply.
Multiple instruments. Use this mode when you plan to stack multiple instruments on a single MIDI
channel in GigaStudio, and crossfade between one entire instrument and the next using the specied
attenuation controller. In this mode, each band in the Crossfade Editor corresponds to an instrument,
and you must populate the bands by dragging and dropping instruments from the editor’s instrument
list. e fade-in and fade-out points for each band will be applied globally to the corresponding
instrument.
File info: [Alt] + [E] + [I]
is command brings up the File Information Window.