Filter
Top Products
38 TASCAM GigaEditor 4 Manual
2. is will remove any sample that was mapped to
this split, indicated by “Not mapped” where the
sample name would ordinarily be.
Mono and Stereo Samples
When you map a sample, the region will automatically change to mono or stereo if necessary to match the
properties of the new sample. A region cannot contain a mixture of mono and stereo samples, so any
existing mappings will be removed when the switch is made.
1. In this example we have four velocities mapped to four
stereo samples.
2. If we drag a mono sample to the top velocity, the whole
region is changed to mono and this sample is mapped to the
top velocity split as intended.
However, the bottom three samples have been removed. Since
this is now a mono region, the splits can only be mapped to
mono samples.
is chapter has covered the basics of creating an instrument, but we’ve limited our use of dimensions to a
simple velocity split. In the next chapter we’ll take a small step forward by creating a two-dimensional
instrument.