Filter
Top Products
101
Limitr (Limiter)
AmpSim (Amp Simulator)
MicSim (Mic Simulator)
Refer to 99.
Decima (Decimator)
ODHiG (OverDrive/HighGain)
ChFl1 (Chorus/Flanger)
ChFl2 (Chorus/Flanger2)
Phaser
Treml
(Tremolo)
Mt.Dly
(Multitap Delay)
Reverb (Mono Reverb)
Gate
The Gate of 86:MM32: Reverb-Gate is connected to the
Wet output of the reverb.
This means that the on/off switch of the Gate effect is
linked to the Reverb, and will be switched on/off in con-
junction with the Reverb.
Trim (EQ Trim) ..................................0...100 Sets the EQ input level
HEQG (Pre LEQ Gain [dB])......–15...+15dB Sets the gain of Low EQ
LEQG (Pre HEQ Gain [dB])......–15...+15dB Sets the gain of High EQ
Ratio (Ratio)..................1.0:1...50.0:1, Inf:1 Sets the signal compression ratio
Thrsh (Threshold [dB]) .................–40...0dB Sets the level above which the com-
pressor is applied
Attck (Attack)....................................1...100 Sets the attack time
Relse (Release)................................1...100 Sets the release time
GLevel (Gain Adjust [dB]).–Inf, –38...+24dB Sets the limiter output gain
Type (Amplifier Type)............SS, EL84, 6L6 Selects the type of guitar amplifier
LPF (Pre LPF)..................................Off, On Selects whether the harmonic noise
caused by a decrease in sampling fre-
quency is generated or not
HiDamp (High Damp [%]).................0...100 Sets the ratio of cut of the high range
Fs(Sampling Frequency [Hz]).1.00k...44.1k Sets the sampling frequency
Bit (Resolution)...................................4...24 Sets the data bit length
Level (Output Level) .........................0...100 Sets the decimator output level
Mode (Drive Mode)........ Overdrive, Hi-Gain Switching between overdrive and
hyper-gain mode
*Drive (Drive)......................................1...100 Sets the degree of distortion
Level (Output Level) ...........................0...50 Sets the overdrive output level
LoFc (Low Cutoff [Hz])...............20...1.0kHz Sets the center frequency for Low EQ
(shelving type)
LoG (Gain [dB])........................–18...+18dB Sets the gain of Low EQ
Md1Fc (Mid1 Cutoff [Hz])......300...10.0kHz Sets the center frequency for Mid/High
EQ 1 (peaking type)
Md1Q (Q) .....................................0.5...10.0 Sets the band width of Mid/High EQ 1
Md1G (Gain [dB]).....................–18...+18dB Sets the gain of Mid/High EQ 1
Md2Fc (Mid2 Cutoff [Hz])......500...20.0kHz Sets the center frequency for Mid/High
EQ 2 (peaking type)
Md2Q (Q) .....................................0.5...10.0 Sets the band width of Mid/High EQ 2
Md2G (Gain [dB]).....................–18...+18dB Sets the gain of Mid/High EQ 2
DTime (Delay Time [msec]).....0.0...50.0ms Sets the delay time
*Speed (Frequency [Hz])..........0.02...20.0Hz Sets the LFO speed
LFO (LFO Waveform)....................TRI, SIN Selects LFO Waveform
*Depth (Depth)...................................0...100 Sets the depth of LFO modulation
Fdback (Feedback)...................–100...+100 Sets the feedback amount
Mix (Wet/Dry) ................. –Wet...–1:99, Dry,
1:99...Wet
Sets the effect balance of the chorus/
flanger
DTime (Delay Time [msec]).....0.0...50.0ms Sets the delay time
*Speed (Frequency [Hz])..........0.02...20.0Hz Sets the LFO speed
LFO (LFO Waveform)....................TRI, SIN Selects LFO Waveform
*Depth (Depth)...................................0...100 Sets the depth of LFO modulation
Fdback (Feedback)...................–100...+100 Sets the feedback amount
Trim (EQ Trim) ..................................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB])......–15...+15dB Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB]).....–15...+15dB Sets the gain of High EQ
Mix (Wet/Dry)..................–Wet...–1:99, Dry,
1:99...Wet
Sets the effect balance of the chorus/
flanger
*Speed (LFO Frequency [Hz]).0.02...20.0Hz Sets the LFO speed
LFO (LFO Waveform) ....................TRI, SIN Selects LFO Waveform
Manual (Manual)...............................0...100 Sets the frequency to which the effect is
applied
*Depth (Depth) ...................................0...100 Sets the depth of LFO modulation
Reso (Resonance)....................–100...+100 Sets the resonance amount
Mix (Wet/Dry)..................–Wet...–1:99, Dry,
1:99...Wet
Sets the phaser effect balance
LFO (LFO Waveform) ...................TRI, SIN,
Vintage, Up, Down
Selects LFO Waveform
Shape (LFO Shape) .................–100...+100 Determines how much the LFO wave-
form is changed
*Speed (LFO Frequency [Hz]).0.02...20.0Hz Sets the LFO speed
*Depth (Depth) ...................................0...100 Sets the depth of LFO modulation
T1time (Tap1 Time [msec])..........0...680ms Sets the Tap1 delay time
T1lvl (Tap1 Level) .............................0...100 Sets the Tap1 output level
T2time (Tap2 Time [msec])..........0...680ms Sets the Tap2 delay time
Fback (Feedback).....................–100...+100 Sets the Tap2 feedback amount
Mix (Wet/Dry).............. Dry, 1:99...99:1, Wet Sets the effect balance of the multi-tap
delay
HiDamp (High Damp [%]).................0...100 Sets the damping amount in the high
range
Time (Reverb Time [sec]) .......0.1...10.0sec Sets the reverberation time
HiDamp (High Damp [%])..............0...100% Sets the damping amount in the high
range
PreDly (Pre Delay [msec])....... 0...200msec Sets the delay time of the reverb sound
and gate control signal
EQTrim (EQ Trim) .............................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) ..... –15...+15dB Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB]) ....–15...+15dB Sets the gain of High EQ
RevBal (Reverb Balance) .. Dry, 1:99...99:1,
Wet
Sets the effect balance of the reverb
Contrl (Input Reverb Mix)... Dry, 1:99...99:1,
Wet
Sets the balance between the dry and
reverb sounds of the gate control signal
Thrshl (Threshold) ............................0...100 Sets the level to which the Gate is
applied
Polrty (Polarity) ......................................+, – Switches between non-reversed and
reversed Gate on/off
Attack (Attack) ..................................1...100 Sets the attack time
Relse (Release)................................1...100 Sets the release time
EffectIns(1in1outx4)