Filter
Top Products
74
This setting is not valid for the beginning of the
song. Also, if you use trigger recording to continue
recording after the end of a previously-recorded
track, setting other than “000 ms” will cause a cor-
responding length of the previously-recorded
sound to be lost.
Procedure for trigger recording
1 Connect an input device, and adjust the recording
level.
Refer to “1. Selecting the input/record track”
(→p.16).
2 Select the [TRIGGER] “Trigger” tab page, and turn
“TriggerRec” “On” (the [TRIGGER] key will light).
3 Press the [REC] key to enter record-ready mode (the
LED will blink).
4 Begin performing.
When the input level exceeds the threshold level
(“Threshold”), recording will begin automatically.
Refer to “Thr
eshold” and “PreTrigTime.”
5 When you are finished performing, press the
[STOP] key to stop.
Scrub, Play From/Play To, and Slow Play functions can
be switched on/off here.
Each time you press the [SCRUB] key, the setting will
be switched on or off.
By using these functions, you can register Locate and
Mark times more precisely and easily.
On ([SCRUB] key lit):
The following functions will be available.
• Scrub function: Rotate the [VALUE] dial to play
back the track data.
Use this to find a specific location in the song while
listening to the sound. This method is similar to
manually rotating an analog record on a turntable to
find the desired location.
• Play From function: When you press the [PLAY]
key, playback will begin from the currently stopped
location and will stop after two seconds. Then you
will automatically return to the location where play-
back began.
• Play To function: When you hold down the [STOP]
key and press the [PLAY] key, playback will begin
from two seconds earlier than the currently stopped
location, and will continue to the location where
playback had been stopped.
By using the Play From function in conjunction
with the Play To function, you can find a time
location with greater accuracy.
• Slow Play function: When you press the [FF] key,
half-speed playback will begin from the currently
stopped location. When you press the [STOP] key
playback will stop, and you will return to the loca-
tion where playback began.
The sound will play slowly, at a pitch one
octave lower than normal. You can use this
function by itself or in conjunction with a pitch
shifter to learn or practice difficult phrases.
When this is “On,” the [VALUE] dial is used only
for Scrub playback. This means that the [VALUE]
dial cannot be used to set parameter values.
Off ([SCRUB] key dark):
Operation will be normal.
1. Loc (Locate)..............................[000:00.000…]
Change the current time location.
You can rotate the [VALUE] dial to change the cur-
rent time location while listening to the sound and
viewing the waveform.
PreTriggerTime
Threshold
Trigger on
Time at which recording begins
15. SCRUB
1
3
2