Filter
Top Products
109
Chapter 7. Adding Effects
Chapter 7
• The output destination of the signal after passing
through the chorus is set with Output Assign parameter
or Select parameter (PATCH/EFFECTS/PATCH CHO
OUT)/(RHYTHM/EFFECTS/RHYTHM CHO OUT) (p.
158).
• The output destination of the signal after passing
through the Reverb is set with the Output Assign
parameter (PATCH/EFFECTS/PATCH REV OUT)/
(RHYTHM/EFFECTS/RHYTHM REV OUT) (p. 160).
For more on how to set each effect, refer to the pages
shown below.
• Multi-effects → (p. 114)
• Chorus → (p. 156)
• Reverb → (p. 158)
5. Press [EXIT] to return to the PATCH PLAY/RHYTHM
PLAY page.
An asterisk * will be displayed at the left of the Patch/
Rhythm Set group. This indicates that the Patch/Rhythm
Set settings have been modified.
If you select another Patch/Rhythm Set in the group
with an asterisk *, the modified Patch/Rhythm Set
settings will be lost. To keep these modified settings,
perform the save operation (p. 164).
The Settings for Each Tone/
Rhythm Tone
You can set the direct sound’s output method and the
amount of effect applied for each Tone or Rhythm Tone
individually.
1. After confirming you are in Patch/Rhythm Set mode,
select the desired Patch or Rhythm Set (p. 29, p. 39).
2. Press [EDIT] to make the indicator light up, press the
[EFFECTS] function button, and press or to
display the OUTPUT page.
fig.07-04
3. Choose the Tone/Rhythm Tone for which you want to
make settings.
When Selecting a Tone
After turning off the [EDIT] indicator, use TONE SELECT
[1]–[4] to select the tone.
When Selecting a Rhythm Tone
Press the key that accesses the Rhythm Tone you wish to set.
After turning off the [EDIT] indicator, you can also use
TONE SELECT [1]–[4] to select the following setting.
TONE SELECT [1]: move to an octave lower key
TONE SELECT [2]: move to the semitone below
TONE SELECT [3]: move to the semitone above
TONE SELECT [4]: move to an octave higher key
4. Press or to move the cursor to the parameter
you’re going to modify.
Output Assign (Output Assign/Output Level★)
Sets the direct sound’s output method and volume for each
Tone or Rhythm Tone.
MFX: Output in stereo through Multi-effects. You can also
apply Chorus or Reverb to the sound that passes through
Multi-effects.
OUTPUT A: Output to the OUTPUT A (MIX) jacks in stereo
without passing through Multi-effects.
OUTPUT B: Output to the OUTPUT B jacks in stereo without
passing through Multi-effects.
INDIV 1: Output to the INDIVIDUAL 1 jack in mono without
passing through Multi-effects.
INDIV 2: Output to the INDIVIDUAL 2 jack in mono without
passing through Multi-effects.