Filter
Top Products
64
Chapter 4. Zone Settings
D BEAM RANGE
fig.04-17
Lower (D Beam Range Lower)
Specifies the lower limit of the range of the D Beam
controller. Values below this setting will not be output.
Upper (D Beam Range Upper)
Specifies the upper limit of the range of the D Beam
controller. Values above this setting will not be output.
It is not possible to set the lower limit value above the
upper limit, nor can you set the upper limit value below
the lower limit.
D BEAM SENS
fig.04-18
D Beam Sensitivity
This sets the D Beam Controller’s sensitivity. The higher the
value set, the more readily the D Beam Controller goes into
effect. Ordinarily, this is set to 5.
The D Beam Controller sensitivity is a System setting,
and as such cannot be saved as a Performance setting.
Confirming the Settings for Each
Zone (INFO)
When a Single Performance is selected, this information
is disabled.
INFO (Zone Information)
fig.04-19
In this screen, you can check the following information for
each Zone.
• MIDI transmit channel (ch): 1–16
• Transmit switch status (tx): On/Off
• Part connection status (part):
When the Local switch for the currently selected Zone is
set to ON, you can check that Zone and the linked Part.
Parts 1–16 are shown in order from left to right, and
Parts for which the Zone’s MIDI transmit channel and
the Part’s MIDI receive channel coincide are indicated by
a o or a *. For Parts indicated by a *, you can check the
group, number, and name of the Patch or Rhythm Set
assigned to that Part in the lower part of the display.
When linked to multiple Parts, by pressing or ,
you can move the * and change the Part being checked.