Filter
Top Products
116
Chapter 7. Adding Effects
Source (Multi-Effects Control Source)
Sets the MIDI message used to change the Multi-effects
parameter with the Multi-effects Controller. Set this to OFF
when the Multi-effects Controller is not being used.
The following are MIDI messages that can be used as Multi-
effects Controllers.
• Controller numbers 01–31, 33–95 (CC01–CC31, CC33–
CC95)
For more detailed information about Control Change
messages, please refer to “MIDI Implementation” (p.
270).
• Pitch Bend (PITCH BEND)
• Aftertouch (AFTERTOUCH)
• System Controller 1–4 (SYS-CTRL1–SYS-CTRL4): MIDI
messages used as global Multi-effects Controllers
Select SYS-CTRL1–4 if you want to use the controllers
globally for the entire XV-88. MIDI messages used as
System Controllers 1–4 are set with the Control 1–4
parameters (SYSTEM/CONTROL/SYS CTRL ASSIGN 1,
2) (p. 173).
• In Patch/Rhythm Set mode, there are parameters that
determine, for each Tone/Rhythm Tone, whether or not
Pitch Bend, Controller Number 11 (Expression) and
Controller Number 64 (Hold 1) are received (p. 77, p. 97).
When these settings are ON, and the MIDI messages are
received, then when any change is made in the settings
of the desired parameter, the Pitch Bend, Expression,
and Hold1 settings also change simultaneously. If you
want to change the targeted parameters only, then set
these to OFF.
• There are parameters that determine whether or not
specific MIDI messages are received for each MIDI
channel (p. 52). When using the Multi-effects Controller,
confirm that any MIDI messages used for the Multi-
effects Controller will be received. If the XV-88 is set up
such that reception of MIDI messages is disabled, then
the Multi-effects Controller will not function.
Destination (Multi-Effects Control Destination)
Sets the Multi-effects parameters to be controlled with the
Multi-effects Controller. The Multi-effects parameters
available for control will depend on the Multi-effects type.
For details, refer to “Multi-Effects Types” (p. 117).
Sens (Multi-Effects Control Sensitivity)
Sets the amount of the Multi-effects Controller’s effect that is
applied. To make an increase in the currently selected value
(to get higher values, move to the right, increase rates, and so
on), select a positive value; to make a decrease in the
currently selected value (to get lower values, move to the left,
decrease rates, and so on), select a negative value. When both
positive and negative are selected, the changes are greater as
the value increases. To have no effect applied, select 0.
MFX OUT (MFX Output)
fig.07-11
Output (Multi-Effects Output Assign)
Adjusts the output destination of the sound that has passed
through the Multi-effects.
A: Output to the OUTPUT A (MIX) jacks in stereo.
B: Output to the OUTPUT B jacks in stereo.
If the Mix/Parallel parameter (SYSTEM/SETUP/
SYSTEM SETUP) is set to MIX, all sounds are output
from the OUTPUT A (MIX) jacks in stereo (p. 169).
Dry (Multi-Effects Dry Send Level)
Adjusts the volume of the sound that has passed through the
Multi-effects.
Chorus (Multi-Effects Chorus Send Level)
Adjusts the amount of Chorus for the sound that passes
through Multi-effects. If you don’t want to add the Chorus
effect, set it to 0.
Reverb (Multi-Effects Reverb Send Level)
Adjusts the amount of Reverb for the sound that passes
through Multi-effects. If you don’t want to add the Reverb
effect, set it to 0.