Filter
Top Products
131
Chapter 7. Adding Effects
Chapter 7
21: TIME CONTROL DELAY
This effect allows you to use a specified controller (the
controller selected in Multi-effects Control Source) to control
the delay time and pitch in realtime (Multi-effects Controller
p. 115). Lengthening the delay will lower the pitch, and
shortening it will raise the pitch.
fig.MFX-21
Delay (Delay time) #
Adjust the time delay from the direct sound until when each
delay sound is heard.
Accel (Acceleration)
This parameter adjusts the time over which the Delay Time
will change from the current setting to a newly specified
setting. The rate of change for the Delay Time directly affects
the rate of pitch change.
Fbk (Feedback Level) #
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Pan (Output Pan)
Adjust the stereo location of the delay sound. L64 is far left, 0
is center, and 63R is far right.
LowGain (Low Gain)
Adjust the gain of the low frequency range.
Hi Gain (High Gain)
Adjust the gain of the high frequency range.
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
Level (Output Level)
Adjust the output level.
22: 2VOICE PITCH SHIFTER
A Pitch Shifter shifts the pitch of the direct sound. This 2-
voice pitch shifter has two pitch shifters, and can add two
pitch shifted sounds to the direct sound.
fig.MFX-22
CoarseA (Coarse Pitch A) #1
Adjust the pitch of Pitch Shift A in semitone steps (-2–+1
octaves).
Fine A (Fine Pitch A) #1
Make fine adjustments to the pitch of Pitch Shift A in 2-cent
steps (-100–+100 cents).
One cent is 1/100th of a semitone.
Pan A (Output Pan A)
Adjust the stereo location of the Pitch Shift A sound. L64 is
far left, 0 is center, and 63R is far right.
PreDlyA (Pre Delay Time A)
Adjust the time delay from when the direct sound begins
until the Pitch Shift A sound is heard.
CoarseB (Coarse Pitch B) #2
Adjust the pitch of Pitch Shift B in semitone steps (-2–+1
octaves).
Fine B (Fine Pitch B) #2
Make fine adjustments to the pitch of Pitch Shift B in 2-cent
steps (-100–+100 cents).
One cent is 1/100th of a semitone.
Pan B (Output Pan B)
Adjust the stereo location of the Pitch Shift B sound. L64 is
far left, 0 is center, and 63R is far right.
PreDlyB (Pre Delay Time B)
Adjust the time delay from when the direct sound begins
until the Pitch Shift A sound is heard.
Mode (Pitch Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
L in
R in
L out
R out
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
2-Band
EQ
Feedback
Time Control Delay
L in
R in
L out
R out
2Voice Pitch Shifter
Level Balance A
Balance W
Balance D
Balance W
Balance D
Level Balance B
PanB R
PanA L
PanA R
PanB L