Filter
Top Products
140
Chapter 7. Adding Effects
X-Fbk (Cross Feedback Level)
Adjust the proportion (%) of the phaser sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Step Rate (Step Rate Switch/Step Rate #)
Adjust the frequency of pitch change.
This setting determines whether the pitch is changed in a
stepped fashion (ON) or not (OFF).
Step Rate parameter can be set as a note-value of a
specified tempo. In this case, specify the value of the
desired note.
Mix (Mix Level)
Adjust the volume of the phase-shifted sound, relative to the
direct sound.
LowGain (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Level (Output Level)
Adjust the output level.
42: KEYSYNC FLANGER
Keysync FLanger controls the Flanger by resetting the effect
at the volume of the sound input to the effects device,
restarting from the same pitch each time the Flanger is reset.
This parameter lets your playing dynamics on the keyboard
control the flanger effect.
fig.MFX-42
Pre Dly (Pre Delay Time)
Adjust the time delay from the direct sound until the flanger
sound is heard.
Rate (LFO Rate) #
Adjust the modulation frequency of the flanger sound.
Rate parameter can be set as a note-value of a specified
tempo. In this case, specify the value of the desired note.
Depth (LFO Depth)
Adjust the modulation depth of the flanger sound.
Fbk (Feedback) #
Adjust the proportion (%) of the flanger sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase. Higher settings will
produce a more distinctive sound.
Phase
Adjust the spaciousness of the flanger sound.
Filter (Filter Type)
OFF: A filter will not be used.
LPF: he frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
When Step Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88’s system
(p. 169).
R in
R out
L in
L out
Flanger
Feedback
Feedback
Flanger
2-Band
EQ
2-Band
EQ
When Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88’s system
(p. 169).