Filter
Top Products
134
Chapter 7. Adding Effects
26: OVERDRIVE→CHORUS
This effect connects an overdrive and a chorus in series.
fig.MFX-26
OD Drive
Adjust the degree of overdrive distortion. The volume will
change together with the degree of distortion.
OD Pan (Overdrive Pan) #
Adjust the stereo location of the overdrive sound. L64 is far
left, 0 is center, and 63R is far right.
Cho Dly (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
ChoRate (Chorus Rate)
Adjust the modulation speed of the chorus effect.
Chorus Depth
Adjust the modulation depth of the chorus effect.
Chorus Balance #
Adjust the volume balance between the overdrive sound that
is sent through the chorus and the overdrive sound that is
not sent through the chorus. With a setting of “D100:0W,”
only the overdrive sound will be output. With a setting of
“D0:100W,” only the overdrive sound that is sent through
the chorus will be output.
Level (Output Level)
Adjust the output level.
27: OVERDRIVE→FLANGER
This effect connects an overdrive and a flanger in series.
fig.MFX-27
OD Drive
Adjust the degree of overdrive distortion. The volume will
change together with the degree of distortion.
OD Pan (Overdrive Pan) #
Adjust the stereo location of the overdrive sound. L64 is far
left, 0 is center, and 63R is far right.
Flg Dly (Flanger Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
FlgRate (Flanger Rate)
Adjust the modulation speed of the flanger effect.
Flg Dpt (Flanger Depth)
Adjust the modulation depth of the flanger effect.
Flg Fbk (Flanger Feedback Level)
Adjust the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Flanger Balance #
Adjust the volume balance between the overdrive sound that
is sent through the flanger and the overdrive sound that is
not sent through the flanger. With a setting of “D100:0W,”
only the overdrive sound will be output. With a setting of
“D0:100W,” only the overdrive sound that is sent through
the flanger will be output.
Level (Output Level)
Adjust the output level.
L in
R in
Chorus
Overdrive
L out
R out
Balance W
Balance W
Balance D
Balance D
L in
R in
Flanger
Overdrive
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback