Filter
Top Products
27
Chapter 1. Overview of the XV-88
Chapter 1
Modifying a Value
To modify a value, use the VALUE dial, [INC/+]/[DEC/-] or
[0]–[9] (numeric keys).
fig.01-16
Each parameter has a specific range, so you cannot set
any value smaller than the minimum value or greater
than the maximum value.
VALUE Dial
Rotating the VALUE dial clockwise increases the value,
counterclockwise decreases the value. Holding down
[SHIFT] as you move the VALUE dial increases value
increments so you can make large value changes faster.
[INC/+] and [DEC/-]
Pressing [INC/+] increases the value, and [DEC/-] decreases
it. Keep the button pressed for continuous adjustment. For
faster value increases, keep [INC/+] pressed down and press
[DEC/-]. For decreasing value faster, keep [DEC/-] pressed
down and press [INC/+].
If you press [INC/+] or [DEC/-] while holding down
[SHIFT], the value increments will get bigger.
[0]–[9] (Numeric Keys)
[0]–[9] (Numeric Keys) lets you directly specify a numerical
value. When you enter the number, the value will blink. This
indicates that the value has not yet been finalized. To finalize
the value press the ENTER button. To reverse the sign of the
number (+/-), hold down [SHIFT] and press [0].
Some parameters do not require you to press [ENTER] to
finalize the value.
< Example 1: To enter a value of 38 >
Press [3] → press [8] → press [ENTER]
< Example 2: To enter a value of -60 >
While holding down [SHIFT] press [0] → press [6]
→ press [0] → press [ENTER]
You can switch from a positive to negative numerical
value anytime before you press [ENTER].
Restoring a Previous Value (Undo)
If, after you change a value you decide that you want to go
back to its original value (before you made the change), press
[UNDO/COMPARE]. You can also put your change back in
again by pressing the button once more. The Undo function
can be used when making changes to settings in the sound
generator section. This is convenient when you want to undo
changes or when you want to compare the sound before and
after a change is made.