Filter
Top Products
127
Chapter 7. Adding Effects
Chapter 7
LowGain (Low Gain)
Adjust the gain of the low frequency range.
Hi Gain (High Gain)
Adjust the gain of the high frequency range.
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
flanger sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
chorus sound will be output.
Level (Output Level)
Adjust the output level.
17: STEREO DELAY
This is a stereo delay.
When Feedback Mode is NORMAL:
fig.MFX-17a
When Feedback Mode is CROSS:
fig.MFX-17b
Delay L (Delay Time Left)
Adjust the time from the direct sound until when the left
delay sound is heard.
Delay R (Delay Time Right)
Adjust the time from the direct sound until when the right
delay sound is heard.
Fbk (Feedback Level) #
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Mode (Feedback Mode)
Select the way in which delay sound is fed back into the
effect.
NORMAL: The left delay sound will be fed back into the left
delay, and the right delay sound into the right delay.
CROSS: The left delay sound will be fed back into the right
delay, and the right delay sound into the left delay.
Phase L (Feedback Phase Left)
Select the phase of the left delay sound.
NORMAL: Phase is not changed.
INVERT: Phase is inverted.
Phase R (Feedback Phase Right)
Select the phase of the right delay sound.
NORMAL: Phase is not changed.
INVERT: Phase is inverted.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
LowGain (Low Gain)
Adjust the gain of the low frequency range.
Hi Gain (High Gain)
Adjust the gain of the high frequency range.
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
Level (Output Level)
Adjust the output level.
When Step Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88’s system
(p. 169).
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay