Filter
Top Products
37
Chapter 2. Playing
Chapter 2
3. Confirm that the [EDIT] and [LOCAL/TX] indicators are
extinguished, and, press a Function button to select the
Zone linked to the Part you want played, lighting the
button’s indicator. When the [1-8/9-16] indicator is out,
zones 1–8 can be selected, and when the [1-8/9-16]
indicator is lit, zones 9–16 can be selected.
The Local Switch for the selected zone will be turned
ON.
At the factory settings, there is a one-to-one
correspondence between each of the Zones 1–16 and
Parts 1–16.
The setting here is linked to the setting at the Local
parameter (ZONE/MIDI/MIDI) (p. 60).
4. Repeat Step 3 to set the Local switch to ON for all Zones
linked to the Parts you want to have play.
5. Press [ZONE], getting the indicator to light, and then
press the [KEY RANGE] function button to access the
KEY RANG page.
fig.04-07
6. Turn off the [EDIT] indicator, and press a Function
button to select the Zone whose Local switch is set to
ON. When the [1-8/9-16] indicator is out, zones 1–8 can
be selected, and when the [1-8/9-16] indicator is lit,
zones 9–16 can be selected.
7. Specifies the keyboard range for the Zone. Use the cursor
buttons to move the cursor to “Lower” and set the lowest
note of the range. Move the cursor to “Upper” and set the
highest note of the range.
8. Rotate the VALUE dial or press [INC/+]/[DEC/-] to
specify the range of notes.
By specifying sections for different Zones so that they
overlap each other, you can combine two or more
Patches only in a specific section.
9. When you are finished making settings, press [EXIT] to
return to the PERFORM PLAY page, and begin playing.
Playing Along with Song
Playback (XV-88 Used as a
Multi-timbral Sound Generator)
In a Single Performance, you can sound the single specified
Part (current Part), making this convenient in such situations
as when performing along with songs.
fig.02-11.e
Selecting a Part You Want to Play on
the Keyboard
If a Single Performance is selected, press Function button to
select the Part you want to play. The selected Part is called
the Current Part.
1. Make sure the PERFORM PLAY page is displayed.
2. Confirm that the [EDIT] indicator is extinguished, and
press the Function button to select the Part you want to
play using the keyboard. When the [1-8/9-16] indicator
is out, Parts 1–8 can be selected, and when the [1-8/9-16]
indicator is lit, Parts 9–16 can be selected.
The Part number shown in the upper right of the display
will change.
fig.02-12
• You can also select the Part by pressing or .
• The keyboard controller’s performance data will be
transmitted on the same MIDI channel as the MIDI
Receive channel that is set for the current Part.
(Tx ch.1)
Part 1
(Rx ch.1)
Part 2
(Rx ch.2)
Part 16
(Rx ch.16)
Part 15
(Rx ch.15)