Filter
Top Products
56
Chapter 3. Creating Performances
Confirming MIDI Information for
Each Part (INFO)
INFO (Part Information)
fig.03-19
fig.03-20
The displays allow you to check various settings such as
MIDI message reception status for each Part. This is
convenient when you need to check that the sound generator
is responding correctly to messages from the keyboard or
external MIDI controller.
Mod (Modulation Information)
Breath (Breath Information)
Foot (Foot Information)
Vol (Volume Information)
Pan (Pan Information)
Exp (Expression Information)
Hld (Hold 1 Information)
Bnd (Pitch Bend Information)
Aft (Aftertouch Information)
Sy1–4 (System Control 1–4 Information)
The MIDI message specified as the Control 1–4 parameter
(SYSTEM/CONTROL/SYS CTRL ASSIGN 1, 2)
Vo (Voice Information)
The number of voices used
When a value (except Vo) is changed in the INFO page, a
MIDI message for the changed value is sent to the
internal sound generator and the external MIDI device
over the MIDI channel set for that Part.
Changing the Settings of the
Patch/Rhythm Set Assigned
to a Part
When using Patches in Performance mode, some settings
such as effects settings will be affected by Performance
settings. If you wish to edit a Patch/Rhythm Set while
hearing how it will sound in the Performance, use this
procedure:
* Here we explain how to change the setting of a Patch assigned
to a Part. The procedure for changing the settings of Rhythm
Sets is the same. Substitute “Rhythm Set” wherever “Patch”
appears in a sentence.
1. Make sure the PERFORM PLAY page is displayed.
2. While holding down [PERFORM], press [PATCH].
Both button indicators will light. This will call up the
PLAY page of the Patch assigned to the currently
selected Part.
fig.03-21
3. Press or to select the Part to which the selected
Patch is assigned.
4. The following steps are the same as when you modify a
Patch in Patch mode.
5. When you finish making settings, press [EXIT] to call up
the Play page of the Patch assigned to the Part.
An asterisk * will be displayed at the left of the Patch
group. This indicates the Patch settings have been
modified.
If you select another Patch or Performance in the group
with an asterisk *, the modified Patch settings will be
lost. To keep these modified settings, perform the save
operation (p. 164).
6. To return to the PERFORM PLAY page, press
[PERFORM] or [EXIT].