Filter
Top Products
147
Chapter 7. Adding Effects
Chapter 7
49: PITCH SHIFTER
A Pitch Shifter shifts the pitch of the direct sound. This 3-
voice pitch shifter has three pitch shifters, and can add three
pitch shifted sounds to the direct sound.
fig.MFX-49
Coarse 1:2:3 (Coarse Pitch 1:2:3)
Specify the pitch in semitones for pitch shift 1–3.
Fine 1:2:3 (Fine Pitch 1:2:3)
Make fine adjustments to the pitch of the pitch shift 1–3 in 2-
cent steps.
Pre Delay 1:2:3 (Pre Delay Time 1:2:3)
Specify the time delay from the direct sound until the pitch
shift 1–3 sound is heard.
Fbk 1:2:3 (Feedback Level 1:2:3)
Adjust the proportion (%) of the pitch shift 1–3 sound that is
fed back into the effect.
Pan 1:2:3 (Output Pan 1:2:3)
Specify the stereo location of the pitch shift 1–3 sound. L64 is
far left, 0 is center, and 63R is far right.
Level 1:2:3 (Level 1:2:3)
Specify the volume of the pitch shift 1–3.
Mode (Pitch Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
Balance (Effect Balance)
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the effect sound will
be output.
Level (Output Level)
Specifies the output volume.
50: LOFI COMPRESS
This is an effect that intentionally degrades the sound quality.
fig.MFX-50
Type (LoFi Type)
Lowers the audio quality. The audio quality will worsen as
this setting is increased.
Pre Filter (Pre Filter Type)
Adjust the type of filter that will be applied before the sound
passes through the Lo-Fi effect.
Post Filter 1 (Post Filter 1 Type)
Adjust the type of filter that will be applied after the sound
passes through the Lo-Fi effect.
Post Filter 2 (Post Filter 2 Type/Cutoff Frequency)
OFF: A post filter 2 will not be used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
LowGain (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Pan (Output Pan)
Adjust the stereo location of the output sound. A setting of
L64 is far left, 0 is center, and 63R is far right.
Level (Output Level)
Adjust the output level.
L
R
Pitch 1
Pitch 3
Pitch 2
L out
R out
1
2
3
Lo-Fi
2-Band
EQ
L in
R in
L out
R out
Pan R
Pan L