Filter
Top Products
53
Chapter 3. Creating Performances
Chapter 3
VELO CRV (Velocity Curve)
fig.03-12
Velocity Curve
Velocity Curve selects for each MIDI channel one of the four
following Velocity Curve types that best matches the touch
of the connected MIDI keyboard. Set this to OFF if you are
using the MIDI keyboard’s own velocity curve.
fig.03-13
Phase Lock (Phase Lock Switch)
Set Phase Lock to ON when you want to suppress
discrepancies in timing of Parts played on the same MIDI
channel, or to OFF when you want to leave the expression
timing unchanged.
When the Phase Lock parameter is set to ON, Parts on
the same MIDI channel are put in a condition in which
their timing is matched, enabling them to be played at
the same time. Accordingly, a certain amount of time
may elapse between reception of the Note messages and
playing of the sounds. Turn this setting to ON only as
needed.
Making Settings for Each Part
(PART)
Here you can select the Patch/Rhythm Set assigned to each
Part, and set the volume, pan, pitch, and polyphony of each
Part.
PATCH
fig.03-14
Type (Part Type)
Sets the assignment of a Patch (PAT) or Rhythm Set (RHY) to
each of the Parts.
Group (Patch/Rhythm Set Group)
Selects the group to which the desired Patch or Rhythm Set
belongs.
USER: User
CD-A–H: Memory card A–H
PR-A–F, GM: Preset A–F, GM
XP-A–D: Wave Expansion Board A–D
• Patches/Rhythm Sets of CD-A–H cannot be accessed
unless a memory card (SmartMedia) is inserted into the
MEMORY CARD slot.
• XP-A, B Patches/Rhythm Sets can be selected only if a
Wave Expansion Board (SR-JV80 Series) is installed in
the corresponding slot.
• XP-C, D Patches/Rhythm Sets can be selected only if a
Wave Expansion Board (SRX Series) is installed in the
corresponding slot.
Number (Patch/Rhythm Set Number)
Selects the desired Patch or Rhythm Set by its number. The
name of the selected Patch/Rhythm Set appears in
parentheses.
SETTING
fig.03-15
Level (Part Level)
Adjusts the volume of an individual Part. This setting’s main
purpose is to adjust the volume balance between Parts.
Pan (Part Pan)
Adjusts the pan of each Part. L64 is far left, 0 is center, and
63R is far right.
When the Pan is set for each Patch or Rhythm Set, this
Pan setting moves the position only in reference to those
settings values made in the respective Patch or Rhythm
Set.
Voice Reserve
This setting specifies the number of voices that will be
reserved for each Part when more than 128 voices are played
simultaneously.
It is not possible for the settings of all Parts to total an
amount greater than 64. The remaining number of
available voices will be displayed at (rest= ). Pay
attention to this readout as you make set the Voice
Reserve parameter.
2134