Filter
Top Products
146
Chapter 7. Adding Effects
48: 3D DELAY
This applies a 3D effect to the delay sound. The delay sound
will be positioned 90 degrees left and 90 degrees right.
fig.MFX-48
Delay C (Delay Time Center)
Adjust the delay time from the direct sound until the center
delay sound is heard.
Delay L (Delay Time Left)
Adjust the delay time from the direct sound until the left
delay sound is heard.
Delay R (Delay Time Right)
Adjust the delay time from the direct sound until the right
delay sound is heard.
Delay C, Delay L and Delay R parameters can be set as a
note-value of a specified tempo. In this case, specify the
value of the desired note.
Fbk (Feedback) #
Adjust the proportion (%) of the delay sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Level C (Level Center)
Adjust the volume of the center delay sound.
Level L (Level Left)
Adjust the volume of the left delay sound.
Level R (Level Right)
Adjust the volume of the right delay sound.
HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut.
If you do not want to cut the high frequencies of the
feedback, set this parameter to BYPASS.
Out (Output Mode)
Adjust the method that will be used to hear the sound that is
output to the OUTPUT jacks. The optimal 3D effect will be
achieved if you select SPEAKER when using speakers, or
PHONES when using headphones.
Lo G (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi G (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Level (Output Level)
Adjust the output level.
L
R
3D Delay L
3D Delay R
3D Delay C
Level
2-Band
EQ
2-Band
EQ
When Delay C, Delay L and Delay R are Set
as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88’s system
(p. 169).