Filter
Top Products
74
Chapter 5. Creating Patches
fig.05-23
This type applies a booster to distort the waveform, and then
combines the two filters. The TVA for Tone 1 (or 3) controls
the volume balance between the two Tones and adjusts
booster level.
fig.05-24
This type uses a ring modulator to create new overtones, and
combines the two filters. The Tone 1 (3) TVA will control the
volume balance of the two Tones, adjusting the depth of ring
modulator.
fig.05-25
This type uses a ring modulator to create new overtones, and
in addition mixes in the sound of tone 2 (4) and stacks the
two filters. Since the ring-modulated sound can be mixed
with Tone 2 (4), Tone 1 (3) TVA can adjust the amount of the
ring-modulated sound.
fig.05-26
This type applies a filter to tone 1 (3) and ring-modulates it
with tone 2 (4) to create new overtones.
fig.05-27
This type sends the filtered Tone 1 (3) and Tone 2 (4) through
a ring modulator, and then mixes in the sound of Tone 2 (4)
and applies a filter to the result.
fig.05-28
This type passes the filtered sound of each tone through a
ring modulator to create new overtones. The TVA for Tone 1
(or 3) controls the volume balance between the two Tones
and adjusts ring modulation depth.
fig.05-29
This type passes the filtered sound of each tone through a
ring modulator to create new overtones, and also mixes in
the sound of tone 2 (4). Since the ring-modulated sound can
be mixed with Tone 2 (4), Tone 1 (3) TVA can adjust the
amount of the ring-modulated sound.
• If you select a Tone while on the STRUCT page, the Tone
paired with the selected Tone will also be selected.
• When TYPE 2–10 is selected and one Tone of a pair is
turned off, the other Tone will be sounded as TYPE 1
regardless of the displayed setting.
• If you limit the keyboard area in which a Tone will
sound (Key Range p. 73) or limit the range of velocities
for which it will sound (Velocity Range p. 72), the result
in areas or ranges where the Tone does not sound is just
as if the Tone had been turned off. This means that if
TYPE 2–10 is selected and you create a keyboard area or
velocity range in which one Tone of a pair does not
sound, notes played in that area or range will be
sounded by the other Tone as TYPE 1 regardless of the
displayed setting.
TONE 1 (3)
TONE 2 (4)
TVA TVF
WG
WG
TVF TVA
B
TYPE 4
TONE 1 (3)
TONE 2 (4)
TVA TVF
WG
WG
TVF TVA
R
TYPE 5
TONE 1 (3)
TONE 2 (4)
TVA TVF
WG
WG
TVF TVA
R
TYPE 6
TONE 1 (3)
TONE 2 (4)
TVATVF
WG
WG
TVF TVA
R
TYPE 7
TONE 1 (3)
TONE 2 (4)
TVATVF
WG
WG
TVF TVA
R
TYPE 8
TONE 1 (3)
TONE 2 (4)
TVATVF
WG
WG
TVF TVA
R
TYPE 9
TONE 1 (3)
TONE 2 (4)
TVATVF
WG
WG
TVF TVA
R
TYPE 10