Filter
Top Products
143
Chapter 7. Adding Effects
Chapter 7
45: MULTI TAP DELAY
The Multi Tap Delay has four delays. Each of the Delay Time
parameters can be specified as a note length of the selected
tempo. You can also set the panning and level of each delay
sound.
fig.MFX-45
Delay 1 (Delay Time 1)
Adjust the delay time from the direct sound until the delay 1
sound is heard.
Delay 2 (Delay Time 2)
Adjust the delay time from the direct sound until the delay 2
sound is heard.
Delay 3 (Delay Time 3)
Adjust the delay time from the direct sound until the delay 3
sound is heard.
Delay 4 (Delay Time 4)
Adjust the delay time from the direct sound until the delay 4
sound is heard.
Delay 1–4 parameters can be set as a note-value of a
specified tempo. In this case, specify the value of the
desired note.
Pan 1 (Output Pan 1)
Sets the stereo position of the delay sound (Delay 1). A
setting of L64 is far left, 0 is center, and 63R is far right.
Pan 2 (Output Pan 2)
Sets the stereo position of the delay sound (Delay 2). A
setting of L64 is far left, 0 is center, and 63R is far right.
Pan 3 (Output Pan 3)
Sets the stereo position of the delay sound (Delay 3). A
setting of L64 is far left, 0 is center, and 63R is far right.
Pan 4 (Output Pan 4)
Sets the stereo position of the delay sound (Delay 4). A
setting of L64 is far left, 0 is center, and 63R is far right.
Level 1
Adjust the output level of delay 1.
Level 2
Adjust the output level of delay 2.
Level 3
Adjust the output level of delay 3.
Level 4
Adjust the output level of delay 4.
Fbk (Feedback) #
Adjust the proportion (%) of the delay sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
HF Damp
Adjust the frequency at which the high frequency range of
the delayed sound returned to the input will be cut.
If you do not want to cut the high frequencies of the
feedback, set this parameter to BYPASS.
LoG (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
HiG (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Lev (Output Level)
Adjust the output level.
L in
R in
L out
R out
Multi Tap Delay
Balance W
Balance D
Balance W
Balance D
Delay 1
Delay 3
Delay 4
Delay 2
Feed
back
2-Band
EQ
2-Band
EQ
When Delay 1–4 are Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88’s system
(p. 169).