Filter
Top Products
153
Chapter 7. Adding Effects
Chapter 7
Filter Type
OFF: A filter will not be used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Out (Output Mode)
Adjust the method that will be used to hear the sound that is
output to the OUTPUT jacks. The optimal 3D effect will be
achieved if you select SPEAKER when using speakers, or
PHONES when using headphones.
Lo G (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi G (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance #
Adjust the volume balance between the direct sound and the
flanger sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the flanger sound
will be output.
Lev (Output Level)
Adjust the output level.
61: 3D FLANGER
This applies a 3D effect to the flanger sound. The flanger
sound will be positioned 90 degrees left and 90 degrees right.
fig.MFX-61
Pre Dly (Pre Delay Time)
Adjust the time delay from the direct sound until the flanger
sound is heard.
Rate (LFO Rate) #
Adjust the modulation speed of the flanger sound.
Rate parameter can be set as a note-value of a specified
tempo. In this case, specify the value of the desired note.
Depth (LFO Depth)
Adjust the modulation depth of the flanger sound.
Fbk (Feedback) #
Adjust the proportion (%) of the flanger sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase. Higher settings will
produce a more distinctive sound.
Phase
Adjust the spaciousness of the flanger sound.
Filter (Filter Type)
OFF: No filter is used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
L
R
3D Flanger
2-Band
EQ
2-Band
EQ
R out
L out
When Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88’s system
(p. 169).