Filter
Top Products
142
Chapter 7. Adding Effects
LowGain (Low Gain)
Specifies the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain (High Gain)
Specifies the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Pan (Output Pan)
Specifies the stereo location of the output sound. L64 is far
left, 0 is center, and 63R is far right.
Level (Output Level)
Specifies the output volume.
44: RING MODULATOR
Ring Modulator is an effect which applies amplitude
modulation (AM) to the input signal, producing bell-like
sounds.
You can also change the modulation frequency according to
the volume of the sound input to the effects device.
fig.MFX-44
Freq (Frequency) #
Sets the frequency at which modulation will be applied.
Mod (Modulator)
Selects the input of the direct sound for the envelope
controlling the modulation.
When set to SRC, the frequency is modulated according to
the envelope of the sound input to the multi-effects.
Mon (Modulator Monitor)
Determines whether the input sound used as the modulator
is output (ON) or not (OFF).
Sens (Sensitivity) #
Sets the amount of frequency modulation applied.
Pol (Polarity)
Determines whether the frequency modulation moves
towards higher frequencies (UP) or lower frequencies
(DOWN).
LowGain (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the effect sound will
be output.
Level (Output Level)
Adjust the output level.
L in
R in
L out
R out
Ring Mod
2-Band EQ
2-Band EQ
Ring Mod