Filter
Top Products
155
Chapter 7. Adding Effects
Chapter 7
63: AUTO PAN
The Auto Pan effect cyclically modulates the stereo location
of the sound.
fig.MFX-63
Mod Wave (Modulation Wave)
TRI: The sound will be modulated like a triangle wave.
SQR: The sound will be modulated like a square wave.
SIN: The sound will be modulated like a sine wave.
SAW1/2: The sound will be modulated like a sawtooth wave.
The teeth in SAW1 and SAW2 point at opposite directions.
fig.MFX-62b
Rate #
Adjust the frequency (speed) of the change.
Rate parameter can be set as a note-value of a specified
tempo. In this case, specify the value of the desired note.
Depth #
Sets the depth to which the effect is applied.
LowGain (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Level (Output Level)
Adjust the output level.
L in
R in
L out
R out
Auto Pan
2-Band EQ
2-Band EQ
Auto Pan
SAW1 SAW2
When Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88’s system
(p. 169).
When Using 3D Effects
The following three 3D effects utilize RSS (Roland Sound
Space) technology to create a spaciousness that cannot be
produced by delay, reverb, chorus, etc.
48: 3D DELAY
60: 3D CHORUS
61: 3D FLANGER
When using these effects, we recommend that you place
your speakers as follows. Also, make sure that the
speakers are at a sufficient distance from the walls on
either side.
fig.RSS
If the left and right speakers are too far apart, or if there
is too much reverberation, the full 3D effect may not
appear.
Each of these effects has an Out (Output Mode)
parameter. If the sound from the OUTPUT jacks is to be
heard through speakers, set this parameter to SPEAKER.
If the sound is to be heard through headphones, set it to
PHONES. This will ensure that the optimal 3D effect will
be heard. If this parameter is not set correctly, the full 3D
effect may not appear.
30˚ 30˚