Filter
Top Products
125
In “Drive,” select your CD-R/RW drive. “Drive” will
indicate Audio CD.
Make the following settings to allow monitoring.
Use “Track” to select the track, and press the
SEQUENCER [START/STOP] key to begin playback.
If you’re using a drive that does not have audio out-
put jacks or a headphone jack, you won’t be able to
monitor the sound.
Saving a track list that you have completed or par-
tially edited
The track list will be lost when the power is turned
off. If you want to keep this data, you must save it.
1 In the Save page, select the directory in which you
want to save the track list.
2 Select the page menu command “Save Audio CD
Track List” to access the dialog box.
3 Press the OK button to save the data, or press the
Cancel button to cancel without saving.
Editing a Wave file: Media, Edit
WAVE
You can edit Wave files stored on media.
This is a convenient way to edit large files to a size that
can be loaded into the TRITON Extreme’s sample mem-
ory (RAM).
• In the Load, Save, Utility, or Make Audio CD page,
select the Wave file you want to edit and then access
this Edit WAVE page.
You cannot edit a Wave file that exceeds 230,400,000
samples (80 minutes at a 48 kHz sample rate).
The sample rates of Wave files that can be edited are
the same as the sample rates supported for KSF files.
(☞PG p.317)
Viewing information about
media: Media, Media Info
You can view information about the media selected by
“Media Select.” You can also mount a device connected to
the USB A connector. (☞PG p.203)
Handling CompactFlash and
Microdrive media
Immediately after use, CompactFlash or Microdrive
media may be at a high temperature. Before removing the
media, power-off the TRITON Extreme and allow the tem-
perature to cool down.
CompactFlash and Microdrive media are precision
devices. Do not bend them, subject them to excessive force
or shock, or drop them. Microdrives in particular are
prone to damage from vibration; handle them with care.
Do not use or store these types of media in locations of
extremely high or low temperature, in direct sunlight, in a
closed automobile, near heating equipment, or in loca-
tions of excessive humidity or dust.
Avoid using or storing these types of media in locations
where there may be strong static electricity or electrical
noise.
Be careful not to let dust or dirt adhere to the terminals of
the CompactFlash or Microdrive media. If the terminals
should become soiled, wipe them lightly with a dry cloth.
When not using media, protect it from static electricity by
keeping it in the protective case that came with it.
Keep media out of reach of infants or children, since they
may place it in their mouth and possibly choke on it or
swallow it.
Carefully read the instructions included with the media.
“Input”: Analog
Input1 “BUS (IFX/Indiv.) Select” L/R, “Level” 127,
“Pan” L000
Input2 “BUS (IFX/Indiv.) Select” L/R, “Level ”127,
“Pan” R127
“Volume” 127
Program
Combination
SequencerSamplingSong PlayGlobalEffectMedia, etcPresetOther