Filter
Top Products
83
right of the display) below +0.0 to an appropriate level.
This adjustment will not affect the output volume, but
will affect the data that will be sampled.
When you have finished making adjustments, press
the SAMPLING [REC] key.
0 Begin sampling.
Press the SAMPLING [REC] key, and then the SAM-
PLING [START/STOP] key to enter recording-standby
mode.
Press the [LOCATE] key to reset the song playback
location to the beginning of the song, and press the
SEQUENCER [START/STOP] key to play back.
If you want to verify the location, press the Prog.9–16
tab to access the Program T09–16 page.
Begin playing at the point where you want to record.
Sampling will begin when the Threshold “Level” vol-
ume is exceeded.
A At the point where you want to stop sampling, press
the SEQUENCER [START/STOP] key.
Song playback and sampling will end.
Sampling will also stop if the specified “Sample Time”
is reached.
Event data and a program will be assigned to the track
you specified in “Select Bank & Smpl No.”
B Press the [LOCATE] key to return to the beginning of
the song, and press the SEQUENCER [START/STOP]
key. Notice that the sampled audio is played back
along with the song.
For details on how the Compare function works for
In-Track Sampling, refer to p.60.
Resampling a song to create a Wave file
Here’s how you can resample your song to media.
A Wave file you resampled to media can be burned to
a CD-R/RW drive connected to the USB A connector
to create an audio CD, refer to p.123.
For details on the types of media you can use, refer to
p.137.
1 In Sequencer mode, select the song from which you
want to create a WAVE file.
Either create a song, or use Media mode to load a pre-
viously-created song.
A maximum of 80 minutes for either mono or stereo
can be written to media in one sampling operation
(mono: approximately 440 Mbytes, stereo: approxi-
mately 879 Mbytes).
2 Access the Sequencer P0: Play/REC, Sampling page.
3 Press the page menu button, and choose “Auto Sam-
pling Setup” from the menu.
A dialog box will appear.
4 Choose “2ch Mix to Media.”
5 Press the OK button to execute the command.
Preparations for In-Track Sampling are now complete.
Let’s take a look at the settings that were made.
Input 1 “BUS (IFX/Indiv.) Select”: Off
Input 2 “BUS (IFX/Indiv.) Select”: Off
Nothing will be input from the INPUT 1, 2 jacks.
“Source BUS”: L/R
The sound sent to the L/R bus will be sampled.
“Trigger”: Sequencer START SW
After you press the SAMPLING [REC] key and the
[START/STOP] key to enter record-ready mode,
recording will begin when you press the sequencer
[START/STOP] key.
“Recording Level”: –12.0
This is the default setting for resampling.
“Save to”: MEDIA
The resampled data will be written to media.
“Mode”: Stereo
The sound of the internal L/R channels will be sam-
pled in stereo.
Program
Combination
SequencerSamplingSong PlayGlobalEffectMedia, etcPresetOther