Filter
Top Products
Style Track Edit functions
E-80 Music Workstation
r
215
■DATA TYPE
Allows you to select the data to be edited.
■FROM NOTE (0 C-~127 G9)
This parameter is only displayed if DATA TYPE (see above) is
set to “Note”. It allows you to set the note (or lower limit of
the note range) to be modified within the specified FROM/
TO time range.
It is not displayed when you select EQUAL, UNEQUAL,
HIGHER or LOWER. See also “Fine-tuning the note range”
on p. 214.
■TO NOTE (0 C-~127 G9)
This parameter allows you to set the upper limit of the note
range to be modified within the specified FROM/TO time
range.
■EXECUTE
Press this field to confirm your settings and edit the
data.
Unlike the ERASE function, DELETE not only erases
the data but also the measures, beats and/or CPT
units, so that all data that lie behind the TO position
are shifted towards the beginning of the track(s). You
cannot choose the data type to be erased.
■TRACK (ADrums~Acc6, ALL)
Allows you to select the track you wish to edit. Select “ALL”
to edit all tracks.
■MODE
Allows you to select the Mode to be edited: “Major”,
“minor” or “7th”.
■DIVISION
Use this parameter to select the Division you want to edit:
Intro 1~4, Main 1~4, Fill Dwn 1~3, Fill Up 1~3, End 1~4.
■FROM/TO
FROM refers to the position where the edit operation is to
begin. That position is specified as a Bar-Beat-CPT cluster.
TO designates the position where the edit operation is to
end (Bar-Beat-CPT). See page 213 for details.
■EXECUTE
Press this field to confirm your settings and edit the data.
See page 208 for a step-by-step discussion. This
function also allows you to copy tracks from other
Styles.
ALL: All parameters listed below.
Note: Only note messages.
Modulat: CC01 messages usually used for adding
vibrato (i.e. use of the BENDER/MODULATION
lever).
PanPot: CC10 messages that specify the stereo posi-
tion.
Express: CC11 messages that used for temporary vol-
ume changes. This parameter can also be
edited on the MIXER page (see p. 211).
Reverb: Reverb Send messages (how strongly the part
should be processed by the reverb effect). This
parameter can also be edited on the MIXER
page (see p. 211).
Chorus: Chorus Send messages (how strongly the part
should be processed by the chorus effect). This
parameter can also be edited on the MIXER
page (see p. 211).
Prog. C.: Program change messages, used to select
sounds or Drum Sets. Note: by deleting pro-
gram change messages you also dispose of
the related CC00 and CC32 (bank select) mes-
sages.
P.Bender: Pitch Bend data (i.e. use of the BENDER/MOD-
ULATION lever).
NRPN Dr: Changes to the pitch of certain drum instru-
ments. See page 211.
DELETE
COPY