Filter
Top Products
Miscellaneous
246
r
E-80 Music Workstation
Note: The E-80 does not support the Edirol DV-7PR’s dual
stream mode.
• Press the [INIT¥SINGLE¥VALUE] field to reset the cur-
rently selected parameter to its default value.
• Press the [INIT¥ALL¥VALUES] field to reset all parame-
ters to their default values.
(4) Press [V-LINK] again to switch off this function (the
button goes dark).
Note: V-LINK messages are transmitted on MIDI channels 13
and 14.
Note: For details on Clips/Palettes, Dissolve Time, and Color
Difference signals (Cb/Cr), refer to the Edirol DV-7PR manual.
General settings
Here are several functions that apply to the E-80 as a
whole and haven’t been covered elsewhere in this
owner’s manual.
(1) Press the [MENU] button.
The display changes to:
(2) Press the [UTILITY] field, followed by the [GLOBAL]
field.
(3) Press the relevant field in the FEEDBACK column to
switch that function on or off.
(4) Press the [Back] field to return to the menu or the
[EXIT] button to return to the main page.
Song/Arranger Start Priority
Normally, when you attempt to start Arranger playback
while a song is being played back, the Arranger does
not respond. The same is true when you try to start
song playback while the Arranger is running. That’s
because the [SONG÷ARRANGER¥START¥PRIORITY] func-
tion is on and gives priority to the section that is
already running. You can, however, switch this system
off.
In that case, starting Arranger playback while a song is
running will stop the song and launch Style playback. If
the Arranger is running while you press
[PLAY÷STOP¥®÷ª], the song starts and the Arranger
stops.
Note: This switch does not apply when you record using Arranger
backing (see p. 60): there, both sections can work simultaneously.
COLOR CB:
Allows you to change the color. There are five
steps that can be selected by pressing the
lever several times: green, violet, blue, red,
original clip color.
COLOR CR:
Allows you to change the color (green, violet,
blue, red, original clip color).
D Beam Allows you to control several effects (this
depends on the function you assign to the D
Beam controller):
Vinyl RPM‰ Fade to black + playback speed
Cutting‰ Fade to back
Harp, Marimba, Guitar‰ Fade to white
Chimes‰ Lumin
Seashore‰ Sepia
LoFi‰ Color
Sweep‰ Post
Scratch‰ Color Blue
Explosion‰ Color Red
Gunshot‰ Color Violet
Tempo Up & Down + Pitch Up & Down‰
Playback speed
EXIT