Filter
Top Products
Adjusting the Button Sensitivity
On the VS-880EX, function of STATUS button differs
by it is hit and released quickly or it is held for longer
seconds. You can specify the length of this time that
the STATUS button must be held down in order to
change it’s function.
Function When Pressed:
Changes the track status.
Function When Held Down:
Confirms the channel ass-
igned to the track.
1. Press [SYSTEM] several times until “SYSTEM
PRM ?” appears in the display.
2. Press [YES].
3. Press PARAMETER [ ] several times until
“SwitchTime=” appears in the display.
4. Rotate the TIME/VALUE dial.
SwitchTime (Switching Time)
This designates the time the buttons must be held
down (0.3–2.0 seconds) in order to change functions.
5. Press [PLAY (DISPLAY)].
Return to Play condition.
Changing the VS-880EX’s SCSI ID
Number
When connecting SCSI devices with the VS-880EX, the
SCSI ID number of each device must be set so that
none of the devices have the same ID number. The VS-
880EX’s SCSI ID number is set to “7” at the factory.
When connecting the VS-880EX to other SCSI devices
(for example, Zip drives or CD-R drives), be sure to set
the SCSI ID number for these other devices to a num-
ber other than “7.”
If no other SCSI ID number is vacant, it is also possible
to change the SCSI ID number of the VS-880EX.
1. Press [SYSTEM] several times until “SYS DISK
PRM ?” appears in the display.
2. Press [YES].
3. Press PARAMETER [ ] several times until
“SYS DSK:SCSI Self=” appears in the display.
4. Rotate the TIME/VALUE dial.
SCSI Self (SCSI Self ID Number)
This sets the VS-880EX’s own SCSI ID number (0–7).
5. Hold down [SHIFT] and press [STORE (ZERO)].
“STORE OK?” appears in the display.
6. Press [YES].
The song is saved.
7. Press [PLAY (DISPLAY)].
Return to Play condition. The new SCSI ID number
becomes effective from the next time when the VS-
880EX is turned on.
When There Is No Hard Disk Installed
Even when there is no hard disk installed in the VS-
880EX, it still can be used with only a Zip drive con-
nected to the SCSI connector. In such instances, it
takes approximately 30 seconds after the power is
turned on of the VS-880EX to check its internal hard
disk connection status. To avoid this wait, you can
preset the VS-880EX not to attempt to use the internal
hard disk.
1. Press [SYSTEM] several times until “SYS DISK
PRM ?” appears in the display.
2. Press [YES].
3. Press PARAMETER [ ] several times until
“SYS DSK:IDE Drv=” appears in the display.
4. Rotate the TIME/VALUE dial.
IDE Drv (IDE Drive)
When not using the internal hard disk, set this to
“Off.” Normally, this is set to “On.”
5. Hold down [SHIFT] and press [STORE (ZERO)].
“STORE OK?” appears in the display.
6. Press [YES].
The song is saved.
7. Press [PLAY (DISPLAY)].
Return to Play condition. The changed setting
becomes effective from the next time when the VS-
880EX is turned on.
Chapter 13 Making Global Settings and Checking Conditions
167
Chapter 13