Filter
Top Products
4. Press [STATUS] for the track on which you want
to carry out Track Erase.
The STATUS indicator will light red.
5. You can use the TIME/VALUE dial to specify the
V-track that you wish to erase. For example, “1-1”
means “V-track 1 of track 1,” “1-*” means “all V-
tracks of track 1,” and “*-*” means “all V-tracks of
all tracks.”
6. If you want to erase multiple tracks simultaneous-
ly, press repeat Steps 4 and 5.
7. If there are any tracks which you decide not to
erase, press that track's [STATUS] once again.
The STATUS indicator will blink green.
Alternatively, you can use PARAMETER [ ]
[ ] to access the settings for that track, and press
[CANCEL (NO)].
8. Press PARAMETER [ ].
“TRK St=” appears in the display.
9. Rotate the TIME/VALUE dial.
St (Start point)
Specifies the starting time of the segment to be erased.
10. Press PARAMETER [ ].
“TRK End=” appears in the display.
11. Rotate the TIME/VALUE dial.
End (End point)
Specifies the ending time of the segment to be erased.
12. Press PARAMETER [ ].
“TRK Track Erase OK ?” appears in the display.
13. Press [YES].
This executes Track Erase. If you wish to cancel, press
[NO].
14. When the erase is completed correctly,
“Complete” appears in the display, and return to
Play condition.
Modifying the Playback Time of the
Performance Data
(Time Compression/Expansion)
This operation allows you to expand or compress the
playback time of a song to a specified length of time.
You can specify the amount of compression or expan-
sion in a range of 75–125%, but the more extreme the
settings, the more adverse the effect will be on the
sound quality. We recommend that you normally keep
compression and expansion within a range of 93–107 %.
CONDITION MARKER#
MASTER
INPUT TRACK
AUX
TIME
48
24
4
0
dB
12
Track for eraseDisplayed blinking
An Easy Way to Specify the Time Settings
Times for the “St” and “End” can be specified
directly without having to display the Track Erase
page. In Play condition, use the following proce-
dure.
1. Move to the beginning of the area that you
wish to erase (“St”).
2. Hold down [TRACK] and press [LOC1/5].
3. Move to the end of the area that you wish to
erase (“End”).
4. Hold down [TRACK] and press [LOC3/7].
If you now access the Track Erase page, the times
that were specified in steps 1–4 will be input as
the time settings for the respective points.
Start To End Time
Start End To Time
Example 1: Compression
Example 2: Expansion
Chapter 6 Editing a Recorded Performance (Track Editing)
96