Filter
Top Products
129
Adding Effects
fig.MFXSetting
For details on these settings, refer to
Making Effect Settings
(p. 125).
* In this setting screen, you can edit the parameters of the multi-effects that is selected by the Multi-effects Type setting. For details on the parameters that
can be edited, refer to
Multi-Effects Parameters
(p. 131).
Parameters marked by can be selected as a multi-effect control destination parameter (see below).
fig.MFXCtrl
For details on these settings, refer to
Making Effect Settings
(p. 125).
* Press [F5 (CTRL)] to switch the multi-effects that will be modified.
* In patch/rhythm set mode, there are parameters that determine, for each tone/rhythm tone, whether or not Pitch Bend, Controller Number 11 (Expression)
and Controller Number 64 (Hold 1) are received (p. 45). When these settings are “ON,” and the MIDI messages are received, then when any change is
made in the settings of the desired parameter, the Pitch Bend, Expression, and Hold1 settings also change simultaneously. If you want to change the
targeted parameters only, then set these to “OFF.”
• There are parameters that determine whether or not specific MIDI messages are received for each MIDI channel (p. 67). When using the
multi-effects control, confirm that any MIDI messages used for the multi-effects control will be received. If the JUNO-G is set up such that
reception of MIDI messages is disabled, then the multi-effects control will not function.
Making Multi-Effects Settings (MFX1–3)
Parameter
Value Explanation
(Multi-Effects Type)
00–78 Selects from among the 78 available multi-effects.
Making Multi-Effects Settings (MFX Control)
Parameter
Value Explanation
Source 1–4
OFF, CC01–31, 33–95,
PITCH BEND,
AFTERTOUCH,
SYS CTRL1–4
MIDI message used to change the multi-effects parameter with the multi-effects control
OFF:
Multi-effects control will not be used.
CC01–31, 33–95:
Controller numbers 1–31, 33–95
PITCH BEND:
Pitch Bend
AFTERTOUCH:
Aftertouch
SYS CTRL1–4:
MIDI messages used as common multi-effects controls
If you want to use common controllers for the entire JUNO-G, select “SYS CTRL1”–”SYS CTRL4.” MIDI mes-
sages used as System Control 1–4 are set with the Sys Ctrl 1–4 Source parameters (p. 160).
Destination 1–4 Refer to p. 131. Multi-effects parameters to be controlled with the multi-effects control
The multi-effects parameters available for control will depend on the multi-effects type. For details, refer to
Multi-Effects Parameters
(p. 131).
Sens 1–4 -63– +63 Amount of the multi-effects control’s effect that is applied
To make an increase in the currently selected value (to get higher values, move to the right, increase rates, and
so on), select a positive value; to make a decrease in the currently selected value (to get lower values, move to
the left, decrease rates, and so on), select a negative value. For either positive or negative settings, greater ab-
solute values will allow greater amounts of change. Set this to “0” if you don’t want to apply the effect.
MFX Control
Channel
1–16, OFF This determines the channel that will be used for reception when using the Multi-effects Control to modify multi-
effects parameters in real time, when the MFX1–3 Source parameter (p. 128) is set to “PRF.” Set this to “OFF”
when the Multi-effects Control is not being used.
* This parameter is not found in Patch mode.
JUNO-G_e.book 129 ページ ２００６年２月１３日 月曜日 午後２時４４分