Filter
Top Products
173
About V-LINK
1.
Press [V-LINK] to access the V-LINK screen.
2.
Press [F6 (SETUP)].
The V-LINK SETUP screen appears.
fig.V-LINK-SETUP
3.
Use [ ] [ ] to move the cursor to the parameter you want to edit.
4.
Use the VALUE dial or [INC] [DEC] to set the value.
* :
On V-LINK compatible devices such as the Edirol DV-7PR/P-1, only Note Tx Channel A is used.
In motion dive .tokyo Performance Package, the Note Tx Channel corresponds as follows.
A: The MIDI channel that controls section A
B: The MIDI channel that controls section B
C: The MIDI channel that controls the MIDI note plug-in
5.
If you want to keep your settings, press [F6 (WRITE)].
6.
Press [F5 (EXIT)] or [EXIT] to return to the previous screen.
V-LINK Settings (V-LINK SETUP)
Parameter
Value Explanation
Note Tx Channel A
1–16 Controls the V-LINK device. Specify the MIDI channel. (
*
)
Note Tx Channel B
Note Tx Channel C
D BEAM Assigns a V-LINK function to the D Beam controller.
OFF The operation selected by [D BEAM] will occur regardless of whether
V-LINK is on or off.
ColorEQ Fore CC1 (Modulation) Used with motion dive .tokyo Performance Pack-
age
ColorEQ Back CC71 (Resonance)
Scratch SW CC3
Speed Knob CC8 (Balance)
Total Fader CC10 (Panpot)
Cross Fader CC11 (Expression)
BPM Sync SW CC64 (Hold)
Clip Loop SW CC65 (Portamento)
Assign Knob CC72 (Release)
Fade Time SW CC73 (Attack)
Visual Knob CC74 (Cutoff)
AB SW CC81 (General-6)
Tap SW CC83 (General-8)
Total Select CC85
FX Select CC86
Play Pos CC91 (Reverb)
LoopStartPos CC92 (Tremolo)
Loop End Pos CC93 (Chorus)
LayerModeSel CC94 (Celeste)
Dissolve Time CC73 (Attack) Used with the DV-7PR and similar devices.
Color Cb Ctrl CC1 (Modulation)
Color Cr Ctrl CC71 (Resonance)
Brightness Ctrl CC74 (Cutoff)
VFX1 Ctrl CC72 (Release)
VFX2 Ctrl CC91 (Reverb)
VFX3 Ctrl CC92 (Tremolo)
VFX4 Ctrl CC93 (Chorus)
Fade Ctrl CC10 (Panpot)
JUNO-G_e.book 173 ページ ２００６年２月１３日 月曜日 午後２時４４分