Filter
Top Products
105
Effects
Effects
fig.ScrFXEdit_GEQ_Guide.eps
GEQ faders
For each frequency band, these adjust the amount of boost
or cut in a range of -15.0dB– +15.0dB.
The value of the fader you operate is shown in the sub-
display area.
Noise may occur when you operate the GEQ faders, but this is
not a malfunction.
EQ ATT (EQ attenuator)
This adjusts the input level to the 31-band GEQ in a range of
-42.0dB – +15.0dB.
The function buttons have the following operations:
* Available only when “GEQ x1” is recalled on both FX1 and FX2 (or FX3
and FX4).
2.
Move the cursor to the desired parameter, and use the
value dial to change the value.
Turning on [F5 (20-630 ON FADER)]–[F7 (630-20k ON FADER)]
will allow you to use the top panel faders to operate the
corresponding bands.
While using the top panel faders to control the 31-band GEQ,
[MUTE] buttons will blink for the faders the position of which is
anything other than 0.0dB. When you press the blinking [MUTE],
the fader will be reset to the 0.0dB position.
[F1 (LINK GEQ1/2)]*
([F1 (LINK GEQ3/4)]*)
Links the 31-band GEQ settings for FX1 and FX2
(or FX3 and FX4).
[F3 (FLAT)] Sets the 31-band GEQ to a flat response.
[F4 (LIBRARY)] Access the FX LIBRARY popup.
[F5 (20-530
ON FADER)]
Allows you to use the top panel faders to
operate the corresponding bands.
[F6 (125-4k
ON FADER)]
[F7 (630-20k
ON FADER)]
[F8 (CLOSE)] Closes the popup.
1
2
1
2
M-300_e.book 105 ページ ２０１０年６月２４日 木曜日 午後２時２６分