Filter
Top Products
141
REAC applications and settings
REAC applications and settings
refer to “REAC connection examples” (p. 139).
5.
Use the setup display area to check the input/output unit
connections, REAC mode settings for the input/output
units, and the signal flow.
For basic knowledge about REAC, refer to “Basic knowledge
about REAC” (p. 13).
For more advanced applications of REAC, refer to “REAC
applications” (p. 138).
To view information about the devices connected to REAC A and
REAC B, you can use the REAC A tab and REAC B tab of the REAC
CONFIG popup.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
2.
Press [F2 (REAC CONFIG)].
fig.ScrSysReacConf1.eps
The REAC CONFIG popup will appear.
3.
Press [F2 (REAC A)] (or [F3 (REAC B)]) to access the REAC A
tab (or the REAC B tab).
fig.ScrSysReacConfABGuide.eps
The REAC A tab (or the REAC B tab) will appear.
Device list
This area shows the devices connected to REAC A or REAC B.
Some devices, like the REAC split devices, may not be shown in
the list.
Device information
This area shows the name, the number of inputs and outputs
and the following information of the selected device:
This area also shows following information:
• S-4000S
You can view the modules that are installed in SLOT1 -
SLOT10.
• S-4000M
You can view the model name and version number of the
units connected to the S-4000M’s port 1–4.
4.
Note the information for the connected REAC device in
the device list and the device information.
If the S-4000M is connected, the function button [F5 (S-4000M
CONFIG)] will appear (p. 142).
Checking the devices connected to REAC
A and REAC B
In some cases, a message like the following may appear after
you select MONITOR/BROADCAST A in step 4.
This confirmation message will appear if there is a difference
in sampling frequency between the FOH console (master)
and the MONITOR/BROADCAST console (split).
If you press [F8 (SET)], the cutoff frequency of the MONITOR/
BROADCAST console will be set to match that of the FOH
console.
If you press [F7 (CANCEL)], the current sampling frequency
will be maintained. If you cancel, it will not be possible to
receive the split from the FOH console.
Firmware Version
Firmware version
REAC Version REAC version
2
1
1
2
M-300_e.book 141 ページ ２０１０年６月２４日 木曜日 午後２時２６分