Filter
Top Products
188
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
4.
Press [F6 (SAVE)].
fig.ScrM48Save.eps
The M-48 SAVE popup will appear.
If you selected a single M-48 unit in step 2, specify a file name.
If you added a check mark to multiple M-48 units in step 2,
specify a folder name. A new folder with the specified name will
be created, and a separate project file for each M-48 unit will be
saved in that folder. The name of each project file will consist of
the “number in the list” + “unit name.”
5.
Edit the name in the name edit field, and press [F8
(SAVE)].
fig.ScrM48Save_Conf.eps
A message will ask you to confirm the operation.
The amount of time required for the save procedure to be
carried out will vary depending on the number of M-48 units
you’ve selected in step 2.
Pressing [F7 (CANCEL)] will cancel the operation.
6.
When you press [F8 (SAVE)], a message indicating the
status of the save procedure will appear.
When saving is finished, the “Completed” message will
appear.
Press [F8 (OK)] to close the message.
Do not disconnect the USB memory or switch off the M-300’s
power while data is being saved to USB memory. Doing so
may damage the data saved on USB memory.
1.
Access the M-48 LOAD/SAVE popup.
fig.ScrM48LoadSave.eps
2.
In the project file list, select the project file that you want
to load.
By selecting a folder and pressing [ENTER], you can move
downward into that folder. By selecting “..” and pressing
[ENTER] you can move back to the folder above the current
one.
3.
In the target unit list, select the M-48 unit into which you
want to load the project.
If you want to load the project into multiple M-48 units, press
[ENTER] to add or clear the appropriate check marks.
By pressing [F1 (MARK ALL)] or [F2 (CLEAR MARKS)] you can add
or clear the check marks in all MARK fields of the target unit list.
4.
Press [F5 (LOAD)].
fig.ScrM48Load_Conf.eps
A message will ask you to confirm the operation.
Loading will require approximately one minute for each unit.
The total amount of time required for loading will depend on
the number of M-48 units you selected in step 3.
Pressing [F7 (CANCEL)] will cancel the operation.
5.
Press [F8 (LOAD)]; the load operation will be executed,
and a message will indicate the processing status.
When loading is finished, the “Completed” message will
appear.
Press [F8 (OK)] to close the message.
Do not disconnect the USB memory or switch off the M-300’s
power while data is being loaded from USB memory. Doing
so may damage the data saved on USB memory.
Loading an M-48 project from USB
memory
M-300_e.book 188 ページ ２０１０年６月２４日 木曜日 午後２時２６分